DCCA Source, DFPC Signature or Elrod EPS3


I am trying to find a pc for my Eddie Current Balancing Act which is a 300b/6sn7 preamp/headphone amp.
I have tried WyWires Juice 2 and am currently using HiDiamond P3. I found the HiDiamonds to work extremely well with my Bryston BDP-1 and Lampizator L4G4 but it just didn't do anything for the Balancing Act. I am looking for smooth treble and weighty bass. Most importantly, I am looking for soundstage depth, palpable image and accurate timbre (not asking much, eh?). I am looking to spend ~$500 or so and am now considering a new DCCA Source, a used DFPC Signature or a used Elrod EPS3 (if one were to every come up for sale). I would love to hear from anyone who has had experience with these cables to provide a bit of guidance.
chatnoir

Showing 3 responses by lak

I might be mistaken but I think Audiogon member Jmcgrogan2 has owned the three power cords that you are asking about. You should send him a message through Audiogon and ask him. I would think he would be happy to share whatever he knows with you.
For what it's worth I noticed my HiDimond 3 power cord sounds a very similar to my Elrod EPS 2/S and 3/S power cords.
John, no the HiDimond P-3 is not ribbon design. Granted I've only had the P-3 attached to my freezer for 48 hours (burn in time) and then I put it on my Allnic L-3000 preamp in place of my Elrod EPS 2/S power cord. At the present time all I can say for sure without further listening sessions is the dynamics and detail of the music seem to be the same as the 2/S. If one was looking to purchase the Elrod EPS 2/S or 3/S but could not locate a used one the HiDimond P-3 might be a good replacement.

From their website: "It's Cable with proprietary technology, 4VRC copper cooking for four times in order to obtain a reduction in values of inductance, capacitance and resistance mixed with graphite. Graphite in this solution allows to block the noise generated inside of the cable from the passage of an electrical signal (which is nothing the musical signal) to bring out a perfect signal without any introduction of noise that would spoil the final result. Connectors with contacts in plating silver to ensure maximum energy transfer. PVC insulation. Double-shielded copper braid SILVER with graphite to eliminate any interference which allow a better signal transmission without loss. Technology twisted within the cable to get a great tonal balance. All these innovations bring to have a result that this cable has a huge dynamic impact, a yield in the low-pitched range hot and present detailed and never swell, the exceptional focus, wide soundstage outlined in all its extended size, deeply divided and open, both in height, width and depth. Disarming conflict resolution speed during the attack transients, and fast release, with a propensity for descent below notable, crystal clear but never aggressive, more black around the orchestral plan guaranteeing a record-breaking three-dimensionality. Simply the point of arrival. A cable that is present but does not feel. Shown in all facilities at both solid-state valves of any value.

Technical characteristics: External jacket mm. 140 ; Number of Cond. 4 x 4,5 ; Cond. Graphite/Copper (4VRC); Capacity max. C1 130Pf/C2 255 Pf with schield.; Inductance : 0,75 u/M ; Conductor Resistance:4,95 OHM/ km.;"

Chatnoir, sorry I did not mean to detour your thread, I thought this could be some helpful information to some readers.