DAC straight to power amp?


I know this issue has been discussed before, but I'm having trouble finding clear information or answers, so here goes...

I am currently running a TEAC UD-501 into an integrated amp via its RCA outputs. I just acquired an Odyssey Stratos dual mono power amp. I am planning on getting a preamp, but wont have one for the interim.

Can I run the TEAC directly to the Odyssey via the XLR outputs? Without blowing my speakers up? The issue is that the TEAC has no volume controls and, but I'm thinking that I can use my digital source (Audivarna+ on my Mac) to control the volume. Not ideal, but maybe OK as a temporary solution until a preamp arrives...

But I don't even want to try this if I will risk damaging my equipment. Thoughts?
zm

Showing 3 responses by georgehifi


Sorry ZM, I thought the volume control on the front would have done both head phone jack and rca output.

If not then you could use still the headphone jack, as it is also a low 32ohm output impedance, though it may be a bit higher in output voltage, more like 6v like an active preamp would be anyway. But you'll need an stereo rca to headphone adapter.

Cheers George

I believe the volume is controlled by the TEAC UD-501 Dac.
I don't believe the computer controls the volume in this case, it just gives a digital output signal, coax (spidf) or optical (toslink)output to the Teac, the volume is then controlled from there.
Just like it would with a separate CD transport and dac

Cheers George

Zm hi.

Your Teac has a wonderful low output impedance of 22ohms with 2v output, your Stratos is 22kohm input impedance and only needs 1.5v for full output.

As you can see the Teac is a perfect impedance and voltage match, you can't ask for better, absolutely no need for a preamp. Unless you wish to colour the sound a little.

Cheers George