Custom Plating for amplifier faceplate......any possible problems

If I were to plate an amplifier faceplate with copper plating simply for cosmetic reasons.

Will this cause any harm to the power amplifier from a functionality stand point?

Its for the smaller Bel Canto power amp.


Its chrome plating or maybe copper plating finish not anodizing. Basic plating.

Original faceplate is aluminum. Screws are connected to the faceplate from the inside of the amp.

Would not wish to fry anything up......




Do your own prep on the parts before sending to the plating company. And then "Still", Pay to have the plater go over them again before the process begins. Otherwise you have only about a 50/50 shot of not having problems. "If they do the final prep? And there was a problem anywhere in the process? "Like someone sneezed"? It happens!  They will just redo it". If they do not ? ANY off-marks or coloring at all will have you paying twice PLUS the extra prep work!
 Also, Either clear anodize OR use three coats minimum of a good polyurethane as a final topcoat.
Copper is very soft and scratches easily. The plating must have a spec. for depth also, "Give to the plating Co.". But, DO NOT, ask for a spec.. OR allow their,  "Shop tolerance spec."
"Otherwise the plating, "May" be so thin it rubs/wears off simply after cleaning several times! Especially with oxidation.
 "Brass", because of it's inherent properties may in fact be a better choice for you. And you can have the topcoat anodizing "Tinted", to give it some UV protection as well as a cool coloring shading. Look at "Red". 
Hee hee, NOT, "RED",  anodizing though". That would be atrocious!
 If you do go with clear anodizing in the topcoat you MUST spec that depth also. "In Microns". And always give the "Finish" in the scale that they use. "You can look at (Shop finish gauges), online to see what I am talking about. "I forget that particular scales name and rate system though....."
 You can ask your plater to show you
exactly what they use as, "Finish Gauges", and go from there. "This you can then pic, AT the plating shop". That's all they should need.
 If they look confused when you ask about anything I have mentioned here? Run. Let JoBob and Jr.Bob, make those x-mas ornaments while you find a real plating company.
Raw copper will oxidize to have a satin brown color. Unless you don't mind the color or polishing your face plate at intervals, bad idea but only from a cosmetic stand point. You could have it clear lacquered after plating I suppose or you could have it gold plated:)
Thank you all for your updates in helping me on this, when can I post a pic so that all of you can see this :) 
It turned out like a "million bucks". Thank you everyone and works just fine.
Some of the vintage gear had copper faceplates and they looked awesome. Can you show a picture of the finished project?I made a set of Model 19 Altec crossovers for my Altec project, stand alone, made the control panel from 1/8" thick brushed brass. Looks fantastic.