Something is wrong. Check your wires/speaker connection and make sure there is no short.
Connecting Klipsch Cornwall to Rotel RA-1062
I recently purchased a system.
Luxman SQ-N150 Amp
Luxman DA-250
Klipsch Cornwall IV
Bi-Amp speaker cables ( these were recommended but I am new to bi-amping/bi-wiring)
The amp is on back order so I am using my single Rotel RA1062 until it arrives. If I connect both speakers to A or both to B only one will have sound. A-Left and B-right. If I connect one speaker to A and one speaker to B I get sound but imaging is terrible. Does the bi-amp cable cause the need to use both A and B? I saw on another thread that the poles are reversed when bi-amping. I will try to switch that (assuming A and B are in effect two amps).
Thanks,
Bill
Luxman SQ-N150 Amp
Luxman DA-250
Klipsch Cornwall IV
Bi-Amp speaker cables ( these were recommended but I am new to bi-amping/bi-wiring)
The amp is on back order so I am using my single Rotel RA1062 until it arrives. If I connect both speakers to A or both to B only one will have sound. A-Left and B-right. If I connect one speaker to A and one speaker to B I get sound but imaging is terrible. Does the bi-amp cable cause the need to use both A and B? I saw on another thread that the poles are reversed when bi-amping. I will try to switch that (assuming A and B are in effect two amps).
Thanks,
Bill