Connecting Bluesound Node 2i to Anthem receiver

I first posted in misc audio but I realize the post should be here
My connection is optical to my 1120 Anthem because my installer said the Anthem has the better DAC. Am I better off this way or using the Bluesound RCA jacks to use the Bluesound DAC. I have read posts that recommend digital coaxial. Is there any consensus on the best way to connect the Bluesound. Thanks
Just want to point out, if you're using the 1120's digital room correction, then you'll  have to use it's dac.

I have the BS Node connected to an mrx 720 and use the 720 dac because I didn't want to lose ARC.
@cissado,Thanks for your response. Yes I am using room correction. Should I be using digital coaxial connection instead of optical or does it not matter. Thanks again
Agree with others you should just try it both ways.  For digital the vast majority prefer a 75Ohm digital cable over toslink.  You can get a 1.5m Apogee Wyde Eye from Amazon for only $55 that’s very good — just make sure you follow the directional arrows that are faintly marked.  Hope this helps, and best of luck. 
@soix Thanks for your response. I have been looking into Coaxial cables and I really did know where to start. I don't want to pay a lot of money and I don't want to waste my money on something that is not good. I will check out the Apogee Wyde as you suggested. $55 is the price I would want to spend. Thanks

Post removed