Connecting a Step Up Transformer


I've been reading Art Dudley's article in Stereophile regarding the Step Up transformers in the past two issue with great interest. I currently use a Shelter 901 (0.5mV) with an ARC PH3 SE. My preamp is the ARC LS25 MK I. With analog, I set the output at 24dB, but I still have to crank the volume all the way to the 12 o'clock or 1 o'clock position.

I've been thinking that a step up transformer might be the answer if I want to play with some other low output MC cartridges.

So I have the following questions:

1/ Currently the cartridge loading is set at 100 ohm on the PH3 per Shelter recommendation. If I add a transformer, does it mean I need to go back and change the loading on the PH3 back to 47k ohm?

2/ I take it that when you use a transformer, you will still have to match loading? So it is better to find one that allows you to adjust the loading?

3/ The PH3 only has 54dB gain. ARC recommended using MC cartridges with output higher than 0.6mV. So with a transformer, I should be able to resolve the gain issue, and also be able to use low output cartridges, ones with 0.3mV output, correct?

4/ What type of cable do you need to connect a transformer? I assume the phono cable w/ ground will just go into the transformer. How about from transformer to phonostage? Just a regular pair of RCA interconnects? Do I need a ground cable between the transformer and the phonostage? It would need to be the same length as the RCA cable?

FrankC
gundam91

Showing 2 responses by piedpiper

I wouldn't bother degrading your sound in order to get your volume pot below 12 o'clock. You will need to set the loading to 47k and set the phono gain to the MM setting.
a quiet step up such as a transformer will certainly give less noise, but at the expense of the added degradation of another stage and interconnects.