2. analog
  3. 1193080773

Connecting a Step Up Transformer

I've been reading Art Dudley's article in Stereophile regarding the Step Up transformers in the past two issue with great interest. I currently use a Shelter 901 (0.5mV) with an ARC PH3 SE. My preamp is the ARC LS25 MK I. With analog, I set the output at 24dB, but I still have to crank the volume all the way to the 12 o'clock or 1 o'clock position.

I've been thinking that a step up transformer might be the answer if I want to play with some other low output MC cartridges.

So I have the following questions:

1/ Currently the cartridge loading is set at 100 ohm on the PH3 per Shelter recommendation. If I add a transformer, does it mean I need to go back and change the loading on the PH3 back to 47k ohm?

2/ I take it that when you use a transformer, you will still have to match loading? So it is better to find one that allows you to adjust the loading?

3/ The PH3 only has 54dB gain. ARC recommended using MC cartridges with output higher than 0.6mV. So with a transformer, I should be able to resolve the gain issue, and also be able to use low output cartridges, ones with 0.3mV output, correct?

4/ What type of cable do you need to connect a transformer? I assume the phono cable w/ ground will just go into the transformer. How about from transformer to phonostage? Just a regular pair of RCA interconnects? Do I need a ground cable between the transformer and the phonostage? It would need to be the same length as the RCA cable?

FrankC
gundam91

Showing 2 responses by herman

herman
2,215 posts
 
The closer the volume control is set to wide open the better off you are. If you are 12:00 to 1:00 then you have plenty of gain and it would be better if you could turn it up more, not less.

If you set the volume lower with your CD player then I would be more concerned about that.
herman
2,215 posts
 
I think you are trying to solve a non-existent problem. The phono is not going to be as quiet as the CD no matter what you do. In between songs you will almost always hear some noise. If it doesn't interfere with the music then forget about it. Adding a transformer might make matters worse because they can pick up noise and hum themselves

I would try setting the gain to 12dB and make it up by turning up the volume control. The volume control is not adding noise, it is coming from somewhere before it, probably the phono stage and maybe because you selected more gain from the preamp.

If you can't turn up the volume control past 10:00 with the CD then you have too much overall gain and should select 12dB.
More to discover