2. analog
  3. 1072797742

Cleaning LP...how much fluid is enough/too much?

I'm using a VPI 16.5 and Record Research Labs cleaning solutions. My question is how much of the fluid to pour on the record? Just get it damp, or flood it as much as possible with a little actually spilling over the sides occasionally?

Are there better brushes out there to use for applying and 'scrubbing' than the VPI supplied hard white bristled nylon brush? (actually, I don't scrub but rather just let the turning of the record do the work while I apply very light pressure)

How many turns of the record and how hard should one press with the brush?

I've noticed that there seem to be "surface tension" on some record surfaces and they are resistant to wetting...while others show no tendency to do this at all. (??)

Thanks for the help.

John
Atlanta, GA
jbatlanta

Showing 1 response by jfrech

jfrech's avatar
jfrech
1,816 posts
 
Hi, I use about 10-15 drops of the super cleaner...use a carbon fiber brush to spread around...vacumn 2 rev's.

Then I partially saturate a disc doctor brush with the wash, go around once using the motor. scrub back and forth (with the grooves) once or twice. Vacumn 2 rev's.

Works like a champ for me.

To answer your question...using the vpi brush..not hard...it's job is to spread the fluid only. Let the fluid to the work. I'd say 2 rev's...one will likely do it...but 2 won't hurt. I'd use as much fluid as you can as long as it doesn't spill off the sides much. Also, 2 vacumn tubes seems to help...one for the deep cleaner...one for the super wash.
More to discover