If your AI preamp is out of warranty and you have the schematics, you can probably get a good tech (if you know one) to change a couple of resistors on the premap attentuation board....come to think of it, AI should do this for you at a very low cost.
CD output voltage too high for preamp: what to do?
I have an Audible Illusions preamp which is designed for a 1.5v input signal. I am told that this is standard. My Ayre CX-7e puts out 2.25v. They play beautifully together but I have too little control over volume: I cannot use the preamp vol controls beyond 9 o'clock because it is way too loud. Likewise it is hard to get just the right volume in the limited range available. This is worse with some CDs for reasons I do not know.
Audible Illusions will change the preamp attenuation board for $275, but before I do so I wonder how others have dealt with the problem of newer CD players with higher outputs than their preamps were designed for.
Audible Illusions will change the preamp attenuation board for $275, but before I do so I wonder how others have dealt with the problem of newer CD players with higher outputs than their preamps were designed for.