"How can this possibly confuse you. The sound of the recorded CDR played back on the same CD player sounds better than the sound of the original CD that the CDR was recorded on played on the same CD player". I'm confused! Sounds like gobbledygook to me. But seriously, if the playback machine is the same as the source used for the recording, then scientifically, there cannot be any improvement whatsoever, as any error which is heard during playback of the original CD will also be recorded onto the CDR. In that case the only possibility is that the CDR is the same, or worse; perhaps you prefer the sound even though the bit error rate is higher.
CD Copies...why do they sound worse?
I had a theory that I haven't discarded yet that not all CD blanks are equal in terms of composition. Yes, they all are made of aluminum and polycarbonate, and when you burn a CD you are creating small holes, or dents in the blank. There is the red book standard that must be adhered to, but as in anything else, I'm sure there are better grades of aluminum and poly available, you get what you pay for. Since the laser reads the digital stream by optically scanning the surface of the CD and interpreting either a one or zero, you'd think it's a go/no-go operation. The original and copies do not sound the same, even to the uncritical ear. I thought for a while it may have had something to do with the relative quality of the CD blanks I was using to copy, in other words, the pressing plants simply use a better grade of master CD's. My friend has a contact and we were able to acquire bulk CD blanks from Saturn Disc that makes CD's. No difference, copies still aren't right. I guess we can eliminate the CD blanks for now. Here's where things get a little outside normal thinking in my twisted logic: we know there are error detection and correction schemes used in intrepreting the data on the CD, employed when the bit being read isn't immediately recognizable to the player. Is it possible the home-made copy that was burned using a cheap consumer grade burner, contains more errors? Are the pits burnt in the CD either irregular in shape or depth? Does the laser in these consumer grade CD burner introduce errors? If so, the EDAC is pretty busy, and doesn't always get it right, which would explain a general lack of quality due to latency delays in the data stream while the EDAC does it's work, and in the process is bound to mis-interpret zeros and ones, there is no 100% accurate EDAC. To me, this is a good place to start in terms of understanding the obvious differences in sound quality.