Cardas charges $50 per END, (not per pair) for retermination. It is impossible for anyone but Cardas to reterminate their cable properly no matter how talented you are at soldering. I was a Cardas dealer for many years and have seen how this is done...don't even try.
Cardas Golden Reference - Reterminate?
I've got a long set of CGR cables (XLR) that I plan to slice into smaller, uneven chunks to fit my new system configuration (all single-ended). I'm very capable of re-terminating the cables, and believe that I would likely improve on the termination job that even factory-terminated cables provide (i've carefully studied their work). I have all the necessary connectors, solder, solder pot, iron, rosin, etc.
What I'm seeking is instructions for the main conductors. I'm aware of what to do with the shield & ground/drain wires. However, I'm not sure how to wire the 3 main conductors? That is, 2 for hot & one for ground - or vice-versa?
Help is very much appreciated!
Thanks!
What I'm seeking is instructions for the main conductors. I'm aware of what to do with the shield & ground/drain wires. However, I'm not sure how to wire the 3 main conductors? That is, 2 for hot & one for ground - or vice-versa?
Help is very much appreciated!
Thanks!