Cap life span?

08-06-12: Rodman99999
>If you look at the datasheets of aluminum electrolytic caps; you'll find that their expected life spans are noted in hours, at a certain temperature.

Right. That's usually 85 degrees C but can be 105 degrees C which is hotter than boiling water.

Life doubles with each 10 degrees C lower. At a pleasant 20 degree C room temperature a "1000 hour" capacitor is good for 90,000 hours or 10 years of continuous service. 2000 hours is more typical which nets 20 years.

People who turn their equipment off when not listening and will find their electrolytic capacitors much longer lived. Averaging 8 hours a day they might last longer than you do.

>08-06-12: Reb1208
>When talk of replacing electrolytic caps comes up on this and other forums. Most people are concerned with the larger can style caps found in amps and preamps.

Those are generally (output capacitors on an OTL tube amp would be an exception) the only ones which see significant ripple currents which make them hot inside and therefore likely to fail.

>Overlooked are the dozens of small value electrolytic caps such as those found in cd players, remote controls, secondary power supplies etc etc.

For electronics only powered up where you're listening to them with reasonable ventilation I'd expect those to outlive their first owner.

>Never had a Electrolytic cap go bad on me.

My Lexicon home theater preamp became inoperable due to a failed electrolytic capacitor in the switching power supply which AFAIK was always powered up.

I've replaced electrolytics in my pinball machines where low power supply voltages resulted from the excessive ESR that developed - they really don't like the heat from all the miniature light bulbs in the back boxes.

>Tntate (Threads | Answers | This Thread)

>Cap life span?
On a tight budget. Looking at older amps and need to know if capacitors have a set lifespan. How would I know if they need replacing?

Get some big power resistors which can be wired in parallel to produce an 8 Ohm load with sufficient wattage and validate that your amplifiers aren't clipping at their rated output power.

Or buy an inexpensive ESR meter and validate

http://www.amazon.com/Anatek-Corporation-blueesrassy-Blue-Fully-assembled/dp/B005NI4WE4

In most cases they won't have been run hot enough for long enough to cause damage.