Can I use 24 gauge speaker cable?

I’ve been trying to google this but I only get vague answers.
I want to know if I can use 24 gauge cable as speaker cable. And if not: why not?
Usual answers are “no, you should use xx gauge”, but I’m looking for why is that? Will the speakers of the amp go off in flames if the resistance is too high? I don’t even get that because the resistance isn’t even that much of a difference between speaker cable sizes, compared to the speakers resistance.

I’m talking about ca 16ft / 5m distance between amp and speaker. By the way should that measure 16 ft or double (32ft because one cable is plus and the other minus)?
sjeesjie, AFAIK biwiring can have effect on the sound by eliminating skin effect (I don’t believe it’s audible) and by reducing back EMF injection into other xover section by separating them by impedance of the driver+wire / impedance of the amp output divider. Xover suppresses it but is not perfect. It works with some speakers and has no effect with the others. I believe it is related to xover design.

3,946 posts
10-17-2020 3:47pm
Dynamic speakers, in general, have their lowest impedance at low frequencies and small gauge wire will result in reduced bass.
"Not necessarily. Many speakers have impedance dip around 100Hz - bass reflex hump. Taming it might be a good thing. I took randomly one of Stereophile measurements - Wilson Sasha, that shows impedance dip to around 2 ohms at 100Hz (at the volume hump) and impedance increase to about 9 ohm at 45Hz where you want it louder (lowest bass string, open E=41Hz). Small wire resistance in series helps to normalize it."

I consider 100Hz to be low-frequency because its handled by the woofer. Also, I would NEVER consider adding resistance in series to normalize things. Using that logic, adding a 1Kohm in series will normalize things even better. 
I put some thought into it a couple years back and my opinion hasn't changed. I have some older Infinity Ren 90 speakers that dip fairly low in the impedance curve.
Excerpt from my old post:
I may try the Dueland 12 gage. I just feel the 16 gage can't handle the power requirements. I relate it to trying to run a skill saw using a lamp extension cord. It'll go round and round, but if you want to cut some serious wood, you'll want a good #10 extension cord.
100Hz is too strong, in most cases, and small resistance in series helps to reduce it, since there is also impedance dip at this frequency. Nobody talks about kiloohms - that’s not a valid argument.

All I’m saying thin speaker wire might change sound to somebody’s liking. My power amp Benchmark AHB2 is perhaps the quietest and most accurate amplifier on the planet, but not everybody likes it.
No , next question ,if you did It would have enough voltage 
to run the topend and maybe mids, at best the midBass,low bass takes power to drive and a awg 24 cannot carry that much voltage, the woofers properly ,if you want your woofers to sound like a pop corn machine with a kick drum or Tom  Toms.a preamplifier probably so,
that is why it is called a preamplifier ,