Can I mix 5 ohm ( Front L/R) and 8 ohm (Surround & Sub) in a 7.1 speaker setup ?

I have 2 Martin Logan speakers with 5 ohm impedance and 5.1 Boston Acoustics speakers with 8 ohm.

I am planning connect all together and create a 7.1 home theater setup.

Can I connect all these 7 speakers with different Ohm rating at a time in the same receiver ?

If yes , what should be the impedence I have to set in the amp ? 6ohm or 8 ?

Kindly advise.

The below is my speakers & Amp I am having :

AV receiver : Yamaha RX V-575
Front speakers : Martin Logan Motion 15 (5 Ohm)
Surround : Boston Acoustics A 2310 HTS 5.1 (8 Ohm)

krishnaanish08-30-2017 10:52am

Post removed Sep 15, 2017
Post removed Aug 31, 2017
elevick Details Discussions Posts This discussion Message User 2,636 posts 08-30-2017 at 11:40pm Copy Comment URL Report Comment Edit Delete You are gonna cook your amp. The more speakers you use, the higher the impedance needs to be for that receiver. Since 5 ohms is the average, just think if you get a 3 or 4 ohm dip. You could buy an external multichannel amp or just a more robust receiver.
erik_squires Details Discussions Posts This discussion Message User 15,627 posts 08-30-2017 at 05:25pm Copy Comment URL Report Comment Edit Delete The amp supports a minimum of 6 Ohms. Set it to that for your fronts, but it will be a little bit of a squeeze. The lower the impedance (Ohms) the harder the speaker is to driver. A 4 Ohm speaker requires 2x as much current as an 8 Ohm speaker. Good luck, Erik
williewonka Details Discussions Posts This discussion Message User 3,063 posts 08-30-2017 at 02:22pm Copy Comment URL Report Comment Edit Delete Provided your amp can drive 5 ohm speakers it should be fine You will probably find the sound levels are out of whack, but you should me able to adjust those separately by speaker grouping (i.e. front/rear/center and left/right balance etc... If your amp does not come with a setup microphone, which you can use to balance the output of the speakers, you should get an SPL meter Regards...