can biwire cables be used on a non-biwire speaker?

I'm not sure how you would make a tight connection with spades and if they are banana's i dont think you would be able to connect a pair to each + and - terminal

I sent my cable back to the manufacturer for a retermination
Thats your best option

I don't see any problem with doing that, as long as the gauge is sufficient. If I understand your question correctly, one of the two pairs of conductors would be left unconnected at the speaker end. Concerns that might be raised about the unconnected wiring would involve possible antenna effects and also capacitance, but I don't think that either has any relevance to an amp/speaker interface, due to the very low source and load impedances.

The following thread addresses a different situation, but I think its conclusions are relevant to your question as well:
http://forum.audiogon.com/cgi-bin/fr.pl?fcabl&1229676493

Regards,
-- Al

I guess I'm asking if I can just connect one pair of leads (high or low) and still get full range?

I know I can't connect them both.

I'm not sure how the bi-wiring on the bedrock works? Is the signal full range for both leads and just gets split inside the speaker? or does it get split inside the cable somewhere?

Al

Thank you! that's what I was trying to say... one of two pairs of leads going to the speaker would be left unconnected. It would just be temporary and I'd zip tie it back and wrap tape on the banana plug so it wouldn't accidentally short out.

I'm not familiar with the particular cable, but I'd feel certain that it does not contain a crossover network that would route different frequencies to one or the other pair of wires.

At most one pair of conductors might be optimized for higher frequencies, in some way, and the other pair for low frequencies. But those differences, if any, would be of comparable magnitude to the kinds of differences that cables normally make.

If the two pairs of conductors differ from each other, I'd suggest using the low frequency pair, to assure adequate gauge.

Regards,
-- Al

Thanks Al

They are the same gauge I think, but I will use the lower freq pair. In face before I box the speakers up I might go ahead and do that just in case there are any differences in sound.

thanks again!

You're welcome! You undoubtedly realize this, but just to be sure, if you try it with your present bi-wire speaker terminals you'll have to jumper the high and low frequency speaker terminals together.

Regards,
-- Al

yes. I just have to find the maggie jumpers.....

I also received an email from a member with AQ knowledge who informed me on how I could remove the banana plugs and combine the strands and make it essentially a full range single run.

If your speakers have 5 way binding posts you can simply put banana connectors on the highs and spades on the lows and connect them both. I seen this used with excellent results on top of the line Nordost cables.

just an update.

Maggies are gone and so are the cables. Back to AQ to be reterminated :)

thanks for all the help.