Calling all Garrard 301's owners/ sophisticated


Hi all,

I just scored a cream, oil bearing Garrard 301 from Ebay Australia. The deck was shipped on Monday and it was delivered to me in California yesterday. After taking the deck out , put the correct pulley on, I gave the deck a run just to test its working condition. As what the seller said, it ran fine, quiet. I was trying to familiar myself with the switches and how the deck work so I did turn it on and off a few times. After deciding that everything was fine, I turned it off and the power cord was still plugged in. About 10 min later, I smelled something burning and sizzling and it turned out that it was the "Spark suppressor" (!Q@#!@) . I quickly unpluged the unit and felt the spark suppressor and it was a bit hot and sticky. Since i have heard of Garrard 301 and Thorens 124's Spark suppressor go bad sometimes, I quickly checked the deck and it still works!!!

Luckily, I found a replacement sold on Ebay UK and I already order 2 of them.

My question is: Is it safe to just go ahead and replace the Spark Suppressor or should I check for anything else before replacing it?

Do you know what is the reason might cause the Spark Suppressor to burn?

Thanks so much in advance!!!
jaytea

Showing 1 response by jaybo

assuming the garrard is not your primary table(next to the sme), i would take it to a turntable specialist(even if it takes a while) for the once-over. Even if you are a DIYer at heart, i would still do this.....nice system