Calling Aerial 20T owners


I just acquired an used pair of 20T V1.

room size is 14 x 18, sources are VPI SSM Ref w/ rim drive, Lyra Skala, Einstein phono, modded Benchmark DAC USB, Einstein pre, BAT 150SE. IC are Audience 24 & Pure Note, speaker wires are Acoustic Zen Hologram II (top) and Audioquest Clear III (bottom). all sit on Grand Prix Audio racks.

due to room size, speakers are 5' from back wall. I had to bi-wire them to remove a bit of bright and edgy top end. not sure if it was the speaker wires or power amp output, I am not getting the "presence" and immediacy like Sonus Faber Amati or Guarneri Memento. I am afraid to use silver speaker cables which will improve the presence, think listening fatigue will set in after 10 min.

want to check with 20T owners:

anyone has success with tube amps?
how far apart do you have them? any toe-in?
how do you move them on carpet? 2-piece construction means I have to take the head unit off every time I want to move a quarter inch.
do you put anything under the speakers? considering some maple block so I can slide them around easily.
Aerial suggests to tilt the speakers up slightly, but after bi-wire I found level sounds better. do you tilt up?

I am happy with the bass response, so I "don't" need more power. but if power will increase upper mid and brings out a bit more presence, snappiness, and immediacy, I will consider a different amp.
semi

Showing 1 response by brainwater

Disclaimer :I an a dealer for both companies ... I run my 20 Ts to great success with the Conrad Johnson Lp 1P 140 monoblocs. I have heard the 20Ts with many ss amps and there are some wonderful combinations to be sure . That said , I wouldnt trade this combination .