Hi spoutjack - I didn't think bdp24 was making a recommendation for line level vs high level hookup as much as asking you which you were using (that being line level). I agree with you. My impression starting out with a pair of SVS subs was that pre-out to line level in was the preferred way to go. I compared line level with speaker level hook up, however, and to my ears and with my gear, I thought speaker level sounded better. I'm not trying to extend my approach to others but was hoping bdp might have experience with speaker level sub connections and an associated cable recommendation. Thanks for your response. |
Spoutjack - Try both ways and see what sounds best to you. There's no right or wrong about it in any absolute sense....just go with whatever gives you the best sound. I came across this old thread. Might be useful to you (this is what I was asking bdp24 about). https://forum.audiogon.com/discussions/speaker-cable-for-bass?highlight=speaker%2Bcable%2Bfor%2Bsubwoofer |
Hello again bdp - I actually used some Romex initially (leftover standard 12 gauge stuff from in-wall house wiring for 20 amp service). I’m running the subs connected to the terminals of my speakers and positioned alongside each so I only need a short run. I couldn’t get a good purchase tightening down on the bare wire ends of the Romex so I switched to doubled-up lamp cord that fit some spades i had. Doubt I’ll hear a difference but would like to pretty things up while keeping the cost as low as possible. The Kimber 8PR is pretty affordable: 5 foot, unterminated, single run (I can cut it in half) under $60. I’m thinking Romex might be a wise choice for delivering over 2000 watts. |
