Building stands for Harbeth 40.2's


I talked with my builder today. I told them I would reach out for more expert opinions on a final design.

Since the TonTragers are the benchmark for Harbeth stands, I'm trying to match them as much as possible.

Question 1- The TonTragers have a 1 inch riser in each corner of the top of the stand. Is this critical for optimal sound ? Or would it be sufficient for the speaker to sit flat on the top of the stand ?

Question 2- Obviously the top needs to be open except for the exterior frame, but can the base be a solid flat piece of wood...or should that be open also ?

Please chime in with any ideas...also I plan on using some good cone spikes on the bottom.

I've attached a pic of the TonTrager for reference for the above questions.

Thanks in advance.

krelldog

Showing 2 responses by mijostyn

Funny you should mention. I am in the process of making stands for Harbeth P3ESR XDs. The base of the stand should have 4 adjustable spikes to engage the floor. I am turning a single spindle with a unique shape averaging 6" in diameter. It is hollow and will be filled with lead shot. The top plate is triangular with three 1" tall 1.5" diameter dowels at each corner. I will attach the speaker with 3M carpet tape. The stands are overall 36" tall. They are made out of Walnut matching the speakers. 

@bassdude , I have stuck 3M carpet tape to just about anything you can think of. It will not damage a modern polyester finish at all. It will leave a residue that is easily removed with brake cleaning fluid. The most common problem with carpet tape is that it will not stick to some surfaces that is when I switch to 3M high strength mounting tape. That can be a b-tch to get off.