2. cables
  3. 162924-94940

Building Balanced XLR Cables

I am building XLR cables using 3 conductor + shield wire. Typically I would solder the shield to ground, 1 wire to hot, and 1 wire to cold. Should I connect the 3rd wire to the ground (shield), use the 3rd wire as the ground (not use the shield at all), or not use the 3rd wire at all? Thanks in advance.  
drumfishie
Post removed 
auxinput
2,920 posts
 
The 4th wire is not for powered microphones.  Powered microphones use what is called "Phantom power".  This is DC voltage that is applied to the signal wires (pins 2 and 3).

The 4th connection on the XLR plug is connected to the equipment chassis/ground.  This can actually be different than Pin 1 signal ground (which is a common/shared ground for the analog circuits), but not necessarily a different connection on all equipment.
b4icu's avatar
b4icu
553 posts
 
Mr. auxinput

XLR should be by STD. No exceptions. Salt and pepper are from another recipe.
I used, built, tested and opened XLR cables. Many for the VOA (Voice of America) projects I was involved (including a winning bid for a station proposal. I wrote book No.4: Audio and time base sub system).
As a part of that rol, we had an Audio expert from the TV broadcast station in Jerusalem. None of your ideas was Kosher.
Powering a mic?
The XLR cables are not for mics. They are for interconnecting home audio equipment.
I would put more attention on the connectors and pick Nutric.
Swiss made, the best in the industry.
Adding a wire (except the shield) is never used in unbalanced (RCA) interconnects, because of the ground loop problem. Why to use it with XLR?
More to discover