You can remove the flat head grub screw that fixes the armrest in position, thereby freeing the the j-hook/clip arm rest assembly to swing up or down on its metal support rod. Be warned however that removing this grub screw will be difficult - every screw on a TP is glued using a thread adhesive. A drop or two of acetone will usually dissolve the glue making it much easier to remove. You'll want to save the grub screw and obtain a new one as you'll have likely marred the head. In one arm board iteration, I had to do this to allow the arm to clear the lead-in groove as well. Just a slight downward tilt of the clip assembly did the trick, and the armrest is still perfectly functional as friction holds it nicely in place.
Brinkmann Bardo and Tri-Planar VII-U armrest issue
Just got a new Brinkmann Bardo. It was a snap to put the Tri-Planar am to the arm board drilled for this arm.
I measured the spindal to pivot distance of 233.5mm with my Feickert Protractor and set up the cartridge with the MintLP.
The issue I have is when I put down the arm, the arm will touch the arm rest and not fall at the beginning of the first track. By touching the arm rest, the arm is bump to several groove from the beginning of the track 1. I did try to fix this issue for the arm rest being too close to the platter by turning the armpod but without success if I want to keep the right S2P distance. Maybe I am doing something wrong. I would appreciate any comment/help.
I measured the spindal to pivot distance of 233.5mm with my Feickert Protractor and set up the cartridge with the MintLP.
The issue I have is when I put down the arm, the arm will touch the arm rest and not fall at the beginning of the first track. By touching the arm rest, the arm is bump to several groove from the beginning of the track 1. I did try to fix this issue for the arm rest being too close to the platter by turning the armpod but without success if I want to keep the right S2P distance. Maybe I am doing something wrong. I would appreciate any comment/help.