If you want a biamped system why do it in a piecemeal fashion where you have to ensure that the gains are correct and either insert your own filters or feed full range signals to the speaker inputs. Instead, buy an active speaker where the gain is set, there is an appropriate power availability for each driver, the signal is properly bandlimited at the amplifier, and the system was designed as an integrated whole. Then you will end up with the full benefits of separate amplifiers. Otherwise you either have to invest an enormous amount of time designing and testing the system to arrive at system in which you will have any assurance of accurate performance.
biamping question
hi,
sorry, i accidently posted this under speakers. I have a pair of vtl mb 125 mono blocks at 125 per channel, i have ascendo c7 speakers which are power hungry at 87 db. i want to biamp, but am at a loss as to which amp to use with the vtls. Should i get another pair of vtl 125? or should i go ssolid state with more power for the bottom end and use the vtls for the mids and highs. Any input would be much appreciated
thanks
sorry, i accidently posted this under speakers. I have a pair of vtl mb 125 mono blocks at 125 per channel, i have ascendo c7 speakers which are power hungry at 87 db. i want to biamp, but am at a loss as to which amp to use with the vtls. Should i get another pair of vtl 125? or should i go ssolid state with more power for the bottom end and use the vtls for the mids and highs. Any input would be much appreciated
thanks