I also have a pair of Wharfedales (1.6 Modus) and have one amp running the highs and a twin running the lows. Imo it sounds better at moderate/high to high volumes. It also sounds clearer on "complicated" tracks. Now Ravel's Bolero and Orff's Carmina Burana O fortuna is stunning instead of ok.
Bi-amping Question?
I am and amature to highend audio and am trying to get into it by first messing around with low-end eqiupment and learn concepts. Quick question. I have a pair of Wharfedale Diamond 8.4 (rated at 150W-RMS 6ohm impendence). Additionally I have a ROTEL RB985 (5 channel at @ 100W per channel at 8 ohm.) Could I bi-wire/bi-amp the Diamond 8.4s using two outputs for each speaker from the amp (i.e. Use Left Front to power Low Frequency of the Left Speaker and Left Rear to power the High Frequency of the Left Speaker and use similar setting for the right speaker). Since the Stereo pre-amp I have has two outputs for each channel, I was planning to connect Left out to Left Front and Left Rear and Right out to Right front and Right Rear on the Rotel amp. Would this actually make a sonic difference? Putting 100W in High Frequency and 100W in Low Frequency = The speaker being powered with 200W or is it still effectively 100W? Any ideas-under the assumption I am buying no additional equipment?