2. cables
  3. 1136617124

Bi amping and cabling

I have two Carver amps that I use to Bi amp my NHT 2.9's. The question I have is what is the proper way to split the signal coming from the pre amp and deliver the left and right channels to both amps. I am currently using some simple "off the shelf" Y splitters. What should I be using and should these be customs made? It doesn't make sense to use a 1 meter pair for a relatively short interconnect.
fwitt1

Showing 1 response by yioryos

yioryos's avatar
yioryos
723 posts
 
Fwitt1
I would recommend the Bryston 10B active crossover.Look for a used one in Audiogon sometimes under "tweeks" or "miscellaneous EQ".Expect to pay around $900 depending on condition.At least that's the round figure I've seen them sell.
George
More to discover