If you are willing to invest some "elbow grease", and are
into the homebrew method, a " Target" type stand can be made
at a very reasonable cost! The 2x3" rectangular tubing and the top/bottom plates cab be cut to length/dimensions, and can be found at a steel supply company. Some grinding/filing
will be required to finish the edges(the hard part). The columns can then be "soldered" to the top/bottom plates using a propane torch and massive amounts of solder and flux. The finished stands can be painted(I used flat black),
and drilled/threaded for spikes and sand filling. Mine cost
about $75 total, and weigh 100 lbs each. For pictures, email
[email protected] Good luck!
into the homebrew method, a " Target" type stand can be made
at a very reasonable cost! The 2x3" rectangular tubing and the top/bottom plates cab be cut to length/dimensions, and can be found at a steel supply company. Some grinding/filing
will be required to finish the edges(the hard part). The columns can then be "soldered" to the top/bottom plates using a propane torch and massive amounts of solder and flux. The finished stands can be painted(I used flat black),
and drilled/threaded for spikes and sand filling. Mine cost
about $75 total, and weigh 100 lbs each. For pictures, email
[email protected] Good luck!