Best cable for Jumpers


Hello all;
This is my first post and would like to start giving my compliments to everyone.
I am asking for an advice about the best cable to make two pairs of jumpers for my B&W speakers. I don’t like the original ones and besides I loss it. I wave a Transparent Super MM single wire. I am not sure but I think transparent doesn’t sell cable without termination and I am sure that buy a set´s of terminated jumpers will cost a fortune. Since I can do it by myself, what cable do you recommend?
Thanks,
Jveiga
joaoveiga

Showing 1 response by dgarretson

I don't know what type of binding posts B&W uses, but if the nuts come off, excellent jumpers can be made from electronics-grade copper foil with holes punched or drilled through to the diameter of the posts. Solderless, minimal metal mass, negligible skin effect, and cheap. Use polyolefin heat-shrink tube to seal the mid section of each jumper.