I tried putting the ball on both sides of my Aurios and found that when the Aurios was upside up the ball tilted to one side of the screw head or the other. This made alignment impossible. When I tried turning the Aurios upside down I found that the small indent that can hold the ball very unstable in that the ball rolls off very easily and the use of the balls are difficult if not impossible in my situation. When I install one Aurios with the ball on top of the upside down aurios the ball will roll off as soon as I try to install the next Aurios device with a ball on it. The devices work extremely well in my aplication and I am pleased but I cannot figure out how to use the Tungsten balls. Any help would be appreciated.
Aurios and Tungsten balls
I recently got a set of Aurios( the small ones)1.0 which came with the Tungsten balls for each device. Are these balls supposed to be just placed on top of the Aurios. I find that the balls will not be centered but will roll to one of the sides of the Aurios off center. Should the balls be used or should I not be using them with the little aurios. Thanks for your help.