Audio Research CA50 + tube rolling


I recently purchased an ARC CA50 which I like a lot. It betters the Cary SLI-80 sig IMO but that's beside the point.
My question is about tube rolling. Has anyone tried rolling either power or driver tubes in the CA50 and what were the results ?

The only info on the net regarding this is somewhat paranoid thread on diyAudio advising against this and suggesting that ARC designed this amp around Sovtek/EH 6922s
Personally I don't buy it.

I contacted ARC and spoke to some bland dude who I don't think even knew what the CA50 was.
He blurted out something about adjusting the voltage on the side panels of the amp if I want to change the driver tubes.

Anyway, your thoughts, suggestions, advice and experience (good or bad) with tube rolling in this amp will be greatly appreciated.

Thanks in advance to all replies.
akanrg

Showing 1 response by docdan50

The driver tubes have to be matched and the voltage adjusted when they are changed. The procedure may be in the manual. I dont think you can just swap out the tubes.