2. amps-preamps
  3. 1113068342

ARC VTM200 Question

I have ARC VTM200s on ProAc 3.8 and have recently lost the right channel sound. Tube bias readout on the back is showing zero. All tubes appear to be lit up (for what that is worth). Fuse is ok. Anyone have any suggestions for troubleshooting it further or should I just call Audio Research?
Thanks in advance
rlkern_dallas
4 responses Add your response
jafox
1,442 posts
 
I assume you swapped the input cables on the amps to verify each amp is getting a signal. And try swapping speaker cables to eliminate a problem here too. Then a call to ARC makes a lot of sense.
janis001
3 posts
 
Sounds like you lost Bias. Pry resistors for bias. Call ARC
and may god be with you.
rlkern_dallas OP
14 posts
 
Problem was blown fuse on input board (that didn't 'look' like it was blown).
Thanks for the suggestions
Appreciate Leonard's help from ARC
klinerm
80 posts
 
I had the same problem with my VTM 200's. I ended up having to replace a fuse under one of the side panels. I agree, Leonard is a jewel. I'd probably go back to SS if he weren't so helpful (glad he is).
Log in to respond
More to discover
80x80
Audio Research VT 80SE
80x80
Don Sachs 300b stereo
80x80
Aurorasound VIDA Prima Phono Stage Amplifier
- NEW - big sound for a resonable price