Anyone with a Krell KAV-250a that could help?

Is there anyone willing to open up the lid on their amp and look at the voltage switches? About 10 torx screws and maybe 5 minutes time needed...

Look at the photo below:

The three red switches are for the main board and I think I have them switched to 110V (with transformer on left, the series is 2-1-2). The input transformer (the black switch to the far right) should be on 1 for 110V.

Anyone willing to open up and look at their amp in what position the switches are would be greatly appreciated.
This is correct - 2-1-2 setting is for 110V.
Thanks for you help!

220V is 2-2-2 and the black switch (pre transformer) set to 2 (if anyone needed this info...)