Anyone using Nuforce Ref 9 Mono Blocks?

Heres a couple links if interested...Odyssey august 2006, also the new extremes use Vishay resistors, red boards and some fancier top plates for the 2006-2007 models, some other upgrades too from my understanding.

http://www.audiocircle.com/circles/index.php?PHPSESSID=92c0hlsv8833upq3sfhcnr1607&topic=30744.0

http://www.audiocircle.com/circles/index.php?board=10

http://www.avsforum.com/avs-vb/showthread.php?t=682125

If you prefer a boat anchor try out odyssey extremes.. About the same price and return policy you search, with traditional but very powerfull sound, No RFI issues, and put tube pre's in front of them and they easily compete and beat most stuff anywhere near the price. Also, just as many or more accolaids and Zero repair history issues in the reviews up in the hundreds, they are highly praised everywhere and have a long history now, as well as the SAME warranty as bryston with 20 years on all parts no questions.. They also retain good value, about the same as mcintosh gear losing about 1/3rd if used. They killed my bryston, Easily have more power and smoother than my Pass and thresholds from the 90's, have rock bottom bass and control, They also run like the digital amps and never Break room temperature even when driven hard, Brystons run very hot. Nuforce did not do it for me when I tried them, but then again it will be very speaker dependent.

If you have any glare or anything from odyssey, Its A- Due to you have to adjust the Bias to custom setting due to your voltage is not 120 volts in the house and klaus will infact do this on order, but I prefer to keep it at the standard 120 volt and adjust the house to be correct instead, Or B- due to you have either a strange speaker combo with them, or simply a preamp, source etc.. That is a bit forward, needing tubes or different impeadance match. I thought my midrange was a bit raw for the first 50 hours, and also after some break in found them to darken alot and this is due to my voltage was way off needing to fix my outlets and then they are pure liquid. Against one of the warmest solid state amps in the Forte and the Mcintosh's I had they blew them away with soundstage size and depth and at super levels never gave a single offensive sharp note, and never were midrange glaring even with 100 db horns and now on 101 db speakers with super tweeters.. It is all about the basics and getting good stable power to these amps or any amps for that matter without a lot of fluxuation in voltage, I found this out cause I had a monster power center that reads voltage on my other system in the house and at night the voltage would go up to 127 volt which would make any amp spike in the upper mids, even tubes that I had which were Cary's sounded thin and steril and were perfectly fine most days. You can not find a more balanced amp just like if you have a good room and speakers positioned correctly within it, via toe in etc.. is the same with feeding these amps or any with very good power, plus they are DEAD silent so any noise coming from them means some bad power in the house, cause mine don't click, hum or even Hiss on 101 db speakers and its scary cause sometimes you would not know the system is on. Not arguing with above points but you asked for some more feedback and that is mine, But if you do try them for 30 days I can absolutley say leave them on with a music signal running a loop feeding a speaker for 2 weeks and that will sweetn them up a ton, I did not believe it either !