Anyone open up the case on a Bluesound Vault 2?


Curious if anyone has attempted to open the case on any Bluesound players, especially the Vault 2? I very much enjoy my Vault and with a very good digital cable, aftermarket power cable, and Ethernet cable I feel I have really push this player beyond what I was expecting. The internal DAC is fine but I much prefer using it as a transport/streamer feeding another DAC. What I’d like to do is open the case to see if there’s an online fuse or fuses that might be worth switching out to say a Syngestic Blue or Orange. I use the Blue fuses in a couple components and have been very satisfied with them. Not looking to do any heavy mods but maybe change out the fuse. Don’t want to bust the case so curious if anyone has and what’s the trick?
adg101
Found this, but curious if anyone has done it and did a fuse swap? I’ll probably pop the cover tomorrow and see what’s inside and will post my findings if others are curious as well.

“On either end of the recess in which there are the power inlet and ports, there is a ¾” by 2” (approx..) plastic cover. There is a very slight indent on the bottom of each.

Using your fingers or a thin blade, pop off these covers.

Underneath each cap there is one small Phillips screw. The screws may be covered with a piece of transparent tape, sticky on both sides. Remove the screws, and one side of the cover pops off.”