My DCS upconverter outputs to 24/192. However, in running the digital 24/192 signal to my DCS DAC, I am required to use two balanced digital cables or a firewire cable as regular digital coaxial or toslink digital optical cable do not have the capacity to carry the digital signal at this level (at least according to DCS). The DCS stuff is pretty nice as it allows various filtration algorithms to be applied and other adjustments. However, in the 24/192 these filters are not available as their manuals state that when processing at these levels [24/192], these additional controls are not necessary.
Anyone listening to 24/196?
If so, what DAC are you using? The Benchmark can intake those signals, but it downsamples them to 110. The BelCanto can't take them. The Bryston BDA-1 is one of the few non-megabuck DACs that can take 192 as an input.
Anything else under 3k?
From Bryston materials: "The CS-4398 operates in one of three oversampling modes based on the input sample rate. Single-speed mode supports input sample rates up to 50 kHz and uses a 128x oversampling ratio. Double-speed mode supports input sample rates up to 100 kHz and uses an oversampling ratio of 64x. Quad-speed mode supports input sample rates up to 200 kHz and uses an oversampling ratio of 32x."
Anything else under 3k?
From Bryston materials: "The CS-4398 operates in one of three oversampling modes based on the input sample rate. Single-speed mode supports input sample rates up to 50 kHz and uses a 128x oversampling ratio. Double-speed mode supports input sample rates up to 100 kHz and uses an oversampling ratio of 64x. Quad-speed mode supports input sample rates up to 200 kHz and uses an oversampling ratio of 32x."