any fixes for impedance mismatch


i have a hovland hp100 (output imp = 2.5K ohms, rise to 4.3k at 20Hz) going to pass x150.5. ( input imp 10K ohm rca, 20K ohm XLR).

The combo sounded better than x1/x150.5 and many other i tried. Base is not lean.

Are there ways to match the impedance to further improve sound? Ten times rule to avoid current sharing.

hovland rca out only, using rca to xlr connector causes lowlevel hum.
128x128glai

Showing 1 response by definitive

I had a similar problem with Edge Signature 1 amplifers (single ended only) the solution for me was MIT Oracle interconnects they are modular so you can change the connectors however you please. And secondly they have a impedance switch that allows you to match the impedance between componates as needed. Allot cheaper than buying a new amp or preamp !

Good Luck
Definitive