I thought all SME V's were fixed headshells! The SME IV.V has a removeable headshell. Also, check the fluid in the damper.
Ciao,
Audioquest4life
Ciao,
Audioquest4life
Anti skating SME V
I am using my SME20/2A with a Dynavector XV-1s cartridge and it sounds good.
I have a question though. The cartridge tend to skip a bit (towards the spindle) when lowered on the run-in groove.
I have tried to set the anti skating to maximum (3) and this helps, but doesn't eliminate the problem. I have to be most careful when lowering the arm to avoid skipping. I also found that playing a bit with the position of the din-connection, turning it anti clockwise seen from the top, might have helped (not sure), but did not eliminate the problem either. Is there a special position for this connection that is preferable? Will the position of the cable affect the anti skating in any way? I have tried to lower the cartridge on a blank record and the arm goes quite fast towards the spindel even with max anti skating (never experience this problem on my Dynavector arm). I know this is not the correct way to set anti skating, but it should give an indication.
Anybody?
I have a question though. The cartridge tend to skip a bit (towards the spindle) when lowered on the run-in groove.
I have tried to set the anti skating to maximum (3) and this helps, but doesn't eliminate the problem. I have to be most careful when lowering the arm to avoid skipping. I also found that playing a bit with the position of the din-connection, turning it anti clockwise seen from the top, might have helped (not sure), but did not eliminate the problem either. Is there a special position for this connection that is preferable? Will the position of the cable affect the anti skating in any way? I have tried to lower the cartridge on a blank record and the arm goes quite fast towards the spindel even with max anti skating (never experience this problem on my Dynavector arm). I know this is not the correct way to set anti skating, but it should give an indication.
Anybody?