Another Next Best Tweak

This does work, and I noticed an improvement in sound. I used a larger (stronger) Neodymium Rare Earth magnet on the Transformer side in My amp. I had it on for two weeks and can say it is an noticeable improvement, compared to not having the Neodymium magnet.

But being the Audio tweaker that I am, I put a similar size Neodymium magnet on the other side of the outside chassis of my amp. What happen was the sound became much cleaner sounding. The over all sound was louder, especially voices. But in away I liked the sound , but something was missing in the fullness area. So I tried a smaller Neodymium magnet and everything snapped right in place.

The nice but to lean sound was gone. The fullness was back, but better than with the one Neodymium magnet on the Transformer side. Dynamics were better as was the bass. So this combo of different size Neodymium magnets works in my current system. Power amps are the only place I have tried the magnets.

I used the Neodymium magnets on both of my Emotiva UPA-1 mono-blocs amps with great success. I only used one Neodymium magnet on each mono-bloc near the transformer.

Wish I would have thought to try the two magnet combo on each mono amp before I sold them.

Ozzy: Look at my system pictures. I just took some pictures of the Neodymium Magnets I use.

Yes you can place them on the outside chassis cover. I have posted a picture of a handful of the Neodymium Magnet that I have. They are all taken from computer Hard-Drives.

Some are larger than others, but they all are super strong, like you said. I have dozens of these Neodymium Magnets.

BTW you can cleanly break the Magnet from the steel plate by using two channel-locs pliers, and bending the steel back plate on each end to separate the glue holding the Neodymium Magnet. You will hear a slight pop

I like to leave the steel back-plate on, because the flat magnets are to much work to remove. But you can slide them on the chassis of your gear. I guess most would not want to do that for fear of scratching the equipment.

I just tried this magnet tweak on my speaker cables. It works just as good there as it does on my power amp.Like you said Ozzy, the dynamics are better.The bass is deeper Thanks for the tip

I tried them on my DIY Ground Control cables. They work good there. But I did notice that having the magnets away from the DIY Ground Control connectors at least 1 inch but no more the 2 inches makes a big difference in bang or bust in sound. So you may have to slowly (tweak) move the magnets towards the connector to lock in the best sound.