I have one more question if you don’t mind; are there any advantages with one type of volume control over the other?Well, with the regular type volume control, it's probably a potentiometer which is basically a variable resistor and typically these continuously contact a resistive plate, which can wear out and become statick-y over time. The other type is a stepped attenuator, with discrete contact positions which attenuate the signal using a set of resistors. These contacts are discrete steps so at any position the knob is connected to two contacts, one at the input...then the signal passing through a set of resistors, and going to the output contact position. The possibility of wear and tear is less.
A Question About Volume Controls Types
My previous preamp's volume knob had a definite low point and high point. When it was powered down I could rotate the volume up to the maximum setting and if I left it there and switched the preamp on, it would of course come on at full volume.
I'm trying to understand how the volume control works on my McIntosh MA252 integrated amp. When it's turned off and I spin the volume control up, there's no end point; it just free wheels. After I've done that and I power it up, the volume is exactly where it was during my last listening session.
Can someone explain how they work so differently?
I'm trying to understand how the volume control works on my McIntosh MA252 integrated amp. When it's turned off and I spin the volume control up, there's no end point; it just free wheels. After I've done that and I power it up, the volume is exactly where it was during my last listening session.
Can someone explain how they work so differently?