A Better Bluesound AC Cable?


Has anybody replaced the stock C7 IEC (Figure 8) cable on their Bluesound Node 2?
Audioquest makes an affordable 2-prong cable...
https://www.audioquest.com/cables/ac-power-cables/2-pole/nrg-1-5

And a C7 to 3-prong...
https://www.amazon.com/dp/B07DLDNDC2/ref=sspa_dk_detail_2?psc=1&smid=A17IVE6SUAZA2P

Or does it make more sense to use a C7 to standard adapter ?


128x128lowrider57

Showing 1 response by aberyclark

IMO, lowering the noise floor will improve any component. In fact, I could see where you may get more "improvement" with power upgrades then stepping up super high priced interconnects (assuming you have well made interconnects). I'm not certain if $5000 power cables will reduce noise any more than a $200 well made cable, however, most component makers source their OEM cables from the same cheap, mass produced suppliers overseas. Chances are your $4000 amp has the the same power cable that a $99 Best Buy receiver has.