2-ways and 3-ways


Advantages and disadvantages lie in both speaker designs. But lately there have been great advances in electronic parts(capacitors resistors and other crossovers parts) that would lead me to believe that there may be more pros vs cons to go with a 3-way speaker.
Is this true?
With the better materials used in cones and transducers and crossover parts is either 2-way or 3-way looking better than the other?
pedrillo
Just from a simplistic less is more standpoint..2-way on paper has an advantage because its one less crossover in the sensitive hearing range(mid-band)...that being said...there are very good 3-way or more speakers out there...all in the execution...Vandersteen 2 sig comes to mind...at any rate...if you dont plan on a sub...a 3-way becomes more appealing...
If the "3" is the bass then 2 way is superior. Why? Bass does not load in a room in the same physical location as the highs and mids. Also, as mentioned, the XO is more complex and fixed, whereas powered subs have separate control for volume, XO point and phase/polarity.

The problem with most 2 ways is their designers try to get too much bass from them
here's a shocker..it would all come down to what specific speaker you are talking about. its still about balance regardless of the design, when it comes to longterm satisfaction.
Actually, an argument could also be made in the exact opposite direction as well. Advances in materials and electronics have also led to full-range drivers becoming much better. In addition, a full-range driver speaker has NO crossover in the "presence" region, which IMO is always a better solution. If you need deep bass/sparkly highs, roll in a subwoofer or two on the bottom and a supertweeter at the top.
Phasecorrect: Just from a simplistic less is more standpoint...

That is simplistic alright, for if that were the case we would be listening to one piece boomboxes rather than multicomponent systems. :)
If the "3" is the bass then 2 way is superior. Why? Bass does not load in a room in the same physical location as the highs and mids.
Well, I agree, even though 2-way usually *isn't* superior!
BTW, you can get the lower mids/bass channel to mate with the rest in the same position -- at the expense of a few frequencies, however (you have to sacrifice something -- otherwise it won't work at all).