2 way vs 3 way question


Hopefully avoiding all the potential puns....and with the possible exception of deep bass, can a well designed and executed 2 way tower sound as good a well designed and executed 3 way tower when it comes to soundstage, detail, tone, etc....and if so, what are some examples?
snapsc
Instead of asking for the best from a theoretical point, simply ask what’s the best speaker you can afford. 
 
If only looking at new: 
 
KEF R3, KEF R300, Philharmonic BMR (unless you sit far away), NHT C3/C4, Revel M105/M106, and Selah Audio Onesto. Those are the ones I can think of off the top of my head as being some of the best out there at their respective prices.
but because I like precision and not jazz ( i am expecting you to get this Wolf, if anybody does )...

the model 2

29 to 29 KHz plus or minus 3 db
and a fantastic 
32 to 21 KHz plus or minus 1.5

hammer down on low B

maybe I should give up my dinky Taylor bass.....
wolf, normally u and i fully on same page...however it is not like 2’s have little output below 40, in fact the acoustic coupler is capable of much...
i would MUCH rather a good two or three way than poorly integrated HT sounding subwoofers.....which is all to often the norm...sadly..

A 4 string bass guitar's low E string is 41hz, and a 5 string bass low B is about 31hz, and a lot of ambient, drum tone low frequency and other normal stuff exists below 40hz in music. A good sub or two will make a full range speaker seem to sound much better (magic!), and the low frequency "hall sound" on live recordings helps things sound like reality. Subs "charge the room" which, if you get used to them and simply turn them (or it) off for a bit you immediately notice the life force going out the window, so to speak.
used Vandersteen subs and VLR or 1 ci would be fantastic

there is also a pair of what appear to be gently used model 2 signature II on agon right now, under your price target..no subwoofer needed with those..unless you listen to music w meaningful stuff below 40 HZ ( rare IMO )
So, I'd like to re-frame the question and see what people think:

If I'm going to use a decent sub to shore up 45hz and below....and I set a speaker budget of $2000...is it possible to get a 2 way that sounds as good (wide soundstage, good tone, good dynamics) as a 3 way....or does the 3 way just have inherent advantages?
Or they cheaper out on voice coils and decided it was cheaper to use a normal 7" than an over built 5" mid
As for the original question, the imaging from drivers that are closer in size will be better, unless waveguides and phase-plugs are in use. Meaning, this is why most 3-way towers use a 2” to 5” midrange, I’ve seen some companies use a 7” midrange with no waveguides, which means they valued more powerful/deeper bass over better imaging.
@seasdiamond 
 
I don’t see how that distance claim can be made without knowing the distance between the drivers. From what I’ve seen in manufacture recomendations, you need to be 3x the distance between the woofers, so if a traditional 3-way has the tweeter 3ft above the lower woofer, you need to be 9ft away at least so that it sounds coherent.   
With a 15% differential I would listen first but likely gravitate to the 2 way
hard to buy a solid mid, more complex crossover and the larger braced cabinet for that delta.

for example.. look at the hyper frugal but perennial favorite ( 250 k sold ) Vandersteen 2 at about $2,500 a $1,100 premium over the esteemed Model 1

both highly musical but the larger more massive more complex two is not free.


Post removed 
Post removed 
I’d argue a 3-way can’t image as well as a 2-way in most listening locations. Dennis Murphy says ideally your listening location would be around 15+ feet away from a 3-way for it to image as well as a 2-way. So unless you are talking about a concentric 3-way where the woofer is where it would be in a typical 2-way, you won’t get that kind of precise imaging and tend to get a sound that varies quite a bit more in a typical (< 10 ft) listening distance in a medium to small room, especially on the vertical axis IMO a 3-way is a lot more height sensitive.

But that's why I love concentrics...pinpoint imaging with full tonality when you have 3-way+.
Tomic601.... 

good point on on the cost difference... so no more than 15% more on the 3 way as a reference point. 

Just as an example... look at Salk... they have similarly priced 2 ways and 3 ways... at a given price point, can the 2 ways really equal the 3 ways
They sure can. Proac, Spendor, Harbeth, etc. are a few good examples of outstanding two way designs that I am familiar with!
The limiting factor is really the surface area of the woofers.

Yes, and in a lot of situations, a smaller speaker, with a smaller woofer will sound better in a lot of rooms.

What the 3 way really gives you is better dynamic range, but the lower it goes in Hz, the more it will wake up the dragons.

IMHO, a really good compromise is the 2.5 way.

Best,
E