|Click title to read one, or click date to read all below it.|
I'm personally not big on mac / magnepan. in all the postin ... Magfan
Magfan, good luck on the frames. it sounds like a project t ... Dsper
I own the 1.6 model . i recently purchased the 1.7 model. i ... Maplegrovemusic
Listened to 1.7s and bought 1.6. i could not tell any real ... Evilfij
Maplegrovemusic, i just picked up my 1.7's last night so th ... Dsper
Not that it actually matters, dsper, but the 1.7 book recomm ... Magfan
Magfan that is interesting that they now recommend the tweet ... Bwp
Hi magfan, i started with the tweeters to the outside for n ... Dsper
While they are 'new', they will continue to change for a whi ... Magfan
I had seen tweeters "in" on the net. however, the ... Dsper
I like the new instructions. i couldn't ignore them since ... Magfan
Magfan, you are not crazy. i mentioned the tweeter in positi ... Crom
Hi magfan, you are right about waiting some amount of time ... Dsper
Measure from the edge of the speaker directly BACK to the 'front' wall.
Measure from EACH side of the speaker. On my 1.6s, I use the little trim strip as the index.
My speakers measure EXACTLY 30.5" on the inside edge and 34" to the outside edge....both straight back to the front wall.
Speakers are 61" apart, inside edge to inside edge....from the same place I measure to the wall.
A little trig tells me.......just under 11 degrees of toe. The speakers cross well behind my seating position of about 10 or 11 feet.
Magfan (System | Threads | Answers | This Thread)
Hi magfan, i do need to tighten up on my geometry! while b ... Dsper
Nope, never measured anything. in the case of problem roo ... Magfan
I have the magnepan 1.7's plus the other equipment - bob/gar ... Jaymark
Just wanted to add that wendell diller recommends trying the ... Josh358
And while you're at it, don't forget to listen to the pole p ... Magfan
I have heard the 1,7 with dcs puccini + clock jeff rowlan ... Clavil
I have been away from this thread for a while and was quite ... Ronwills
I don't know about the wyred integrates, but several people ... Josh358
I use a psaudio gcc series integrated. it uses the same asp ... Magfan
"11-11-10: charlesjnicholas i've had my 1.7s for nearly ... Vetnik
Have you experimented with setup? panels can require some p ... Magfan
Hey magfan, are you out there? you may remember that i re ... Dsper
Excellent result, dsper. just a little messing around and a ... Magfan
You are right - a free upgrade in about five minutes! i am ... Dsper
One other thing i forgot to mentin is that magnepan provides ... Dsper
Man, what a can of worms! to tilt or not to tilt, that is ... Magfan
Magfan, or anyone, any opinions about the best approach for ... Dsper
I have heard them again but this time with all krell electro ... Clavil
My personal opinion would be to go to a total reframe in rea ... Magfan