AudiogoN
Search Buy Sell Learn MyPage
 Learn > Forums > Speakers > 1247418696  Start New Thread | Log In | Bookmark This
  SPEAKER HUM
I have been playing with a new system. I was driving my speakers with a MingDa MC 34 AB tube amp (75 wt/ch ultralinear 40wt/ch triode) which is powered with 8 EL 34 tubes. It can be used as an integrated amp, and when I used it as such, it was DEAD quiet.
I decided to make a good thing better, and just got the matching MingDa MC 2A3X preamp to go with it. The speaker hum when both are powered up is awful...not that very low level stuff you sometimes get with an amp/preamp set up...but loud enough to hear during quiet passages of musical pieces.
I have been tormented in the past with trying to eliminate speaker hum...any help out there for this system??
Thanks so much
Rsasso  (Threads | Answers | This Thread)

07-12-09
  Responses (1-20 of 20)
Click title to read one, or click date to read all below it.

07-12-09   I do not envy you, it is a pain. my last bout was resolved b ...   Richard_stacy

07-12-09   Have you ruled out bad tube on the preamp (or simply a defec ...   Millicurie999

07-12-09: Almarg
Although it is a bit technical, the following paper provides some good background on system-level causes of hum (as opposed to hum that is introduced within a particular component, which is definitely also a possibility here, as Millicurie suggested):

http://www.jensen-transformers.com/an/an004.pdf

Regards,
-- Al

Almarg  (System | Threads | Answers | This Thread)


07-12-09   To millicurie amp and preamp are plugged into separate outl ...   Rsasso

07-12-09   To millicurie i substituted a small tono preamp for the big ...   Rsasso

07-12-09   Iirc, plugging the amp and pre to separate lines is a very g ...   Swampwalker

07-12-09   At the risk of being too obvious - have you tried a cheater ...   Newbee

07-12-09   To millicurie ok: i substituted the interconnects between a ...   Rsasso

07-12-09   To newbee someone stole my cheater plug. i will get one at ...   Rsasso

07-12-09   that's typical of a microphonic tube (or tubes). hum can al ...   Tvad

07-12-09   I would try another preamp, if you can get your hands on 1. ...   Fplanner2000

07-12-09   To fplanner2000 i have to share my ignorance. don't you ne ...   Rsasso

07-12-09   To tvad, i dont have any of these 6sn7's to rotate right no ...   Rsasso

07-12-09   that's a good question. many of the most sought after and e ...   Tvad

07-12-09   As swampwalker mentioned, amp and preamp in two different ou ...   Millicurie999

07-13-09   To tvad, thanks again for your very knowledgable input on m ...   Rsasso

07-13-09   To millicurie999 since the amp is about 10ft away from the ...   Rsasso

07-13-09   yes, it might. with components that are connected via sing ...   Almarg

07-13-09   One other potential cause of hum would be a cable tv that sh ...   Goose

07-14-09   Another thing to check is whether the tubes are propertly se ...   Cleaneduphippy


  Post your response
Subject


Your response

No html, but you may use markup tags


Username
Members only

Password