|I am thinking about adding a solid-state amp (DNA-500) to my system to drive the bass cabinets of my VR-7se's. Currently I have 1 set of balanced outs going to 2 VAC 300.1s that are each driving a VR-7se speaker full range. The other set is driving my subwoofer.|
If I disconnect the sub and hook up the 500 to these balanced outputs from the pre, with the 500 speaker outputs going to the bass cabinets of the VR-7se's, will this work? Only problem I can see is that both modules of each speaker will be receiving a full range signal, but only using a portion of it depending upon the drivers. Balancing will be a snap as the volume control will control the 500, with the attentuating knobs on the VACs available to balance the rest of the speaker to the bass.
Will I be doing any damage this way? Is there a better way to do this w/o complicating things with crossovers, etc? Does what I'm proposing make sense? The 7's love power and I had the DNA-500 sitting in a closet.... Seems like this way I can get the best of both worlds, with about 750w going to each bass unit and 300 VAC tube watts (50w+/- Class A) going to each mid/tweet/super-tweet module. On paper, seems like a great idea, BUT...Before I go very far down this path, I'd really like to get some feedback and answers to these questions above.
Thanks in advance for any light you can shine in the tunnel.. :-)
BTW- just replaced noisy Dragon 6dj8 pre driver tubes with Seimens NOS 7308's - quieter(obviously), better imaging, bigger soundstage, more air and a bit tighter bass - after 1 hour!! Will only get better - more expensive but worth it IMHO. YMMV.