AudiogoN
Search Buy Sell Learn MyPage
 Learn > Forums > Amps Preamps > 1276356977  Start New Thread | Log In | Bookmark This
  Lightspeed Attenuator - Best Preamp Ever?
The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
Pubul57  (System | Threads | Answers | This Thread)

06-12-10
  Responses (851-900 of 1334)
Click title to read one, or click date to read all below it.

09-14-11   Hope all the testosterone has now been depleted. your questi ...   Georgelofi

09-15-11   My dear fiddler, thanks for your kind words towards my self ...   Teajay

09-15-11   Hi paul, yes, your speculation regarding my use of ss amps ...   Teajay

09-15-11   Hey, hey , hey guys. i personally like the lsa to anything i ...   Marqmike

09-15-11   Hi paul, something else i wanted to share with you but i fo ...   Teajay

09-15-11   Terry i have heard that said about power regulation and beli ...   Pubul57

09-16-11   This thread has taken an amusing turn. teajay, while you st ...   Agear

09-16-11   "would the lay public be able to say "wow, that on ...   Pubul57

09-16-11   Disciplined testing? i don't know. just kept switching betwe ...   Pubul57

09-16-11   I would like to test the lsa against the $16,000 music first ...   Pubul57

09-16-11   Paul, i agree with all of that. speakers and room are easy ...   Agear

09-16-11   One correction to agear's very interesting post. the truth i ...   Clio09

09-16-11   09-16-11 agear: george, does cadmium have a sound? is that p ...   Georgelofi

09-16-11   Anthony, your description of the lsa versus the audio consul ...   Pubul57

09-16-11   Paul just looked at your system, that is a esotar d330 tweet ...   Georgelofi

09-16-11   Yes, and probably why i have stuck with merlins for 9 years, ...   Pubul57

09-16-11   And i forgot to mention, i think the lsa gives me that.   Pubul57

09-16-11   Pubul57: raises the question as to the the "effects&quo ...   Georgelofi

09-17-11: Pubul57
George, I think we are in agreement, as Anthony is likely to be, and it might seem Nelson Pass is likely to be in agreement too, and yet we find many(?) audiophiles that still don't see it that way, and I respect their view as well, but I guess I am just comfortable with my own conclusions, theoretically and in actual listening - and whatever divergence of opinion we have seems like an uncrossable bridge, so we are left with try it and see what you think.

But the argument is also between a $500 approach versus 5-20K approaches, so where do you go from there? I don't know. I can only recommend that folks try it and decide for themselves.

Pubul57  (System | Threads | Answers | This Thread)


09-16-11   From reading a. salvatore's review of the coincident preamp, ...   Banquo363

09-17-11   I should add: what else should we look at other than impedan ...   Banquo363

09-17-11   Need to look at the voltage output of the source compared to ...   Grannyring

09-17-11   09-17-11: banquo363i should add: what else should we look at ...   Georgelofi

09-17-11   In the aleph l manual, np goes on to say, "if you need ...   Pubul57

09-17-11   i used to think this too until i tried my lsa with my atma- ...   Clio09

09-17-11   Actives also need to be well matched with the amp. my cuuren ...   Grannyring

09-17-11   09-17-11: grannyring actives also need to be well matched wi ...   Georgelofi

09-18-11   Sorry george, you have two mistaken assumptions regarding m ...   Teajay

09-18-11   Sorry correction, xa60.5, it is the same 20k for the single ...   Georgelofi

09-18-11   Also if it is feeding any of the bryston xovers this is the ...   Georgelofi

09-18-11   George, i'm sure by reading this thread you know my positio ...   Teajay

09-18-11   you do have a bad match teayjay with or without the use of ...   Georgelofi

09-18-11   George, it just does not seem possible that there is a pream ...   Pubul57

09-18-11   Try to bear with me here and let it sink in. you see this i ...   Georgelofi

09-18-11   Paul one of the tube guru's on diyaudio said the solid state ...   Georgelofi

09-18-11   33k ohm output impedance is rather high, especially given th ...   Clio09

09-18-11   Hi tony,this is what a cascode 12au7 will be judging by the ...   Georgelofi

09-18-11   This is the output description "the 12au7 tubes are on ...   Georgelofi

09-19-11   George, yes i saw that review and was aware of the other inf ...   Clio09

09-19-11   Like i have always said tony, it will work and sound ok with ...   Georgelofi

09-19-11   George, i'm not sure that teajay's "lsa test" was ...   Pubul57

09-19-11   Just ran into this thread. seems another ldr attenuator has ...   Clio09

09-19-11   I just received the october issue of stereophile. please rea ...   Grannyring

09-19-11   I agree with sam, when you need gain or have an impedance mi ...   Pubul57

09-19-11   yes i too received it today, and i need to tell all, before ...   Georgelofi

09-20-11   Pubul57 agreed, sam did not need and active, but wanted one ...   Grannyring

09-20-11   "...however some desire one for the resulting sound ben ...   Jdec

09-20-11   I agree, there is nothing wrong with folks liking coloration ...   Pubul57

09-20-11   At full price the lsa isn't going to break the bank. it's a ...   Clio09

09-20-11   And st is a "cheapskate"....   Pubul57


< Prev << 13 | 14 | 15 | 16 | 17 | 18 | 19 | 20 | 21 | 22 | 23 >> Next >

  Post your response
Subject


Your response

No html, but you may use markup tags


Username
Members only

Password