AudiogoN
Search Buy Sell Learn MyPage
 Learn > Forums > Amps Preamps > 1276356977  Start New Thread | Log In | Bookmark This
  Lightspeed Attenuator - Best Preamp Ever?
The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
Pubul57  (System | Threads | Answers | This Thread)

06-12-10
  Responses (751-800 of 1353)
Click title to read one, or click date to read all below it.

05-14-11   Hi everyone, i stumbled across another lightspeed attenuato ...   Kevinzoe

05-14-11   I think uriah, just sells kits, no?   Pubul57

05-14-11   One type of passive i have not tried are the evs and endler ...   Pubul57

05-14-11   At one time i had the evs and endler attenuators. i preferre ...   Clio09

05-15-11   Pubul57 - uriah selll kits and finished products as per his ...   Kevinzoe

05-15-11   Unless i am missing something, it seems he builds the kit, b ...   Pubul57

05-15-11   hi paul, i can answer a few points for you. 1: nobody as f ...   Georgelofi

05-15-11   Thank you george, it did not seem uriah was doing doing the ...   Pubul57

05-15-11   ...though teak would be nice:)   Pubul57

05-15-11   Teak does not shield against rf, it maybe a step forward in ...   Georgelofi

05-31-11   I've been playing around with interconnects and note that th ...   Banquo363

05-31-11   I must admit that difference between cables simply don't jum ...   Pubul57

05-31-11   I'm not at all a 'cable guy'. it would please me no end if i ...   Banquo363

05-31-11   Banquo363, sent you an email. not sure why the mogami didn' ...   Clio09

05-31-11   Hi guys, interconnect cables can be a mine field, not just w ...   Georgelofi

05-31-11   george, is that what you really meant to say? i would not c ...   Almarg

05-31-11   Yup, and well above the 12pf/ft of the cardas, which is why ...   Pubul57

06-01-11   With the lightspeeds output at worst 7k, this together with ...   Georgelofi

06-17-11   Hi guys, i have a potential future ca distributor, who asked ...   Georgelofi

06-18-11   George, up to now you have distributed your product direct t ...   Clio09

06-18-11   More $$$?   Glory

06-18-11   Would have to be:(   Pubul57

06-18-11   Sorry, i should have made it more clear, it's not for more $ ...   Georgelofi

06-19-11   Sounds good.   Pubul57

06-21-11   Just read the review on the ypsilon active and passive pream ...   Knghifi

06-21-11   King, can you post a link to the review?   Clio09

06-21-11   Knghifi, you do have to wonder how much better it can possib ...   Pubul57

06-21-11   Tony, i only have a hard copy stereophile sub and is in the ...   Knghifi

06-21-11: Clio09
Well at least MF is comparing it to something a bit closer in price. Then again MF liked the LSA too, just wasn't high enough in cost to get Class A rating. I'm sure he'd look pretty stupid to the industry if he said a $500 component was comparable to one that cost $26k, but wouldn't it be interesting if that is what he privately felt;)

From the information I saw on the Ypsilon PST-100TA preamp it has two operational modes, each with a 150 ohm output impedance. One operates in unity gain and the other 20 dB of gain due to a tube output stage IIRC. Leads me to believe this is an active preamp all around, but I could be wrong, just not that much information to go on.

Clio09  (System | Reviews | Threads | Answers | This Thread)


07-09-11   George, i'm sure that the information i need is listed some ...   Devilboy

07-10-11   The source should put out 2v or there about and less than 20 ...   Clio09

07-10-11   Thanks clio09. it's nice to know that you've had success wi ...   Devilboy

07-10-11   Assuming all your ducks are in a row impedance wise and you ...   Clio09

07-10-11   Anthony, you have pretty sensitive speakers, no? might be a ...   Pubul57

07-10-11   My speakers are probably close to 95 db sensitive even thoug ...   Clio09

07-11-11   How do you get music for the otari? pm me, sounds interestin ...   Pubul57

07-12-11   07-09-11: devilboy george,i'm sure that the information i ne ...   Georgelofi

07-19-11   George: interesting concept, but what about the distortion ...   Dhl93449

07-19-11   At line level, at 2vrms which a cdp hardly ever hits, even w ...   Georgelofi

07-20-11   If you wish to see the measurments at cd playing levels, eve ...   Georgelofi

08-30-11   An interesting little snippet for those of you who own or ha ...   Georgelofi

08-30-11   see george, if you use fancy language like this you can get ...   Clio09

08-31-11   Clio09: what exactly is an array of 48 optically controlled ...   Georgelofi

09-05-11   Thinking about those darttzeel and constellation preamps wit ...   Dgarretson

09-05-11   Dgarretson - so you finally were able to get it done. i had ...   Clio09

09-05-11   Dave is using it the way the first mk1 lightspeed attenuator ...   Georgelofi

09-06-11   George, given the non-linearity of ldrs at high impedances, ...   Dgarretson

09-06-11   dave, mkii lsa in a true differential balance circuit topo ...   C1ferrari

09-06-11   Well it might be a great suggestion but in the mkii version ...   Clio09

09-06-11   Indeed adding a buffer stage to an active preamp at input to ...   Dgarretson


< Prev << 11 | 12 | 13 | 14 | 15 | 16 | 17 | 18 | 19 | 20 | 21 >> Next >

  Post your response
Subject


Your response

No html, but you may use markup tags


Username
Members only

Password