AudiogoN
Search Buy Sell Learn MyPage
 Learn > Forums > Amps Preamps > 1276356977  Start New Thread | Log In | Bookmark This
  Lightspeed Attenuator - Best Preamp Ever?
The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
Pubul57  (System | Threads | Answers | This Thread)

06-12-10
  Responses (51-100 of 1334)
Click title to read one, or click date to read all below it.

06-14-10   Like your input george. i would love to try your preamp in m ...   Grannyring

06-14-10   I stand corrected in my morrison elad comments. thanks for t ...   Sibelius

06-14-10   I have never heard a stereo system that sounds like live mus ...   Pubul57

06-14-10   Grannyring i have a gaint in my opinion :-) good on you gr ...   Georgelofi

06-14-10   I had to google it, hmmmm.   Pubul57

06-15-10   Goodness that is funny stuff.............   Grannyring

06-15-10   Maybe we can have a giant gaint ?   Rx8man

06-15-10   Thought well enough of the lightspeed attenuator, that i jus ...   Pubul57

06-15-10   With ralph's assistance i'm tweaking the s-30 so that it wil ...   Clio09

06-15-10   Sorry to hear that paul, (please no hate mail) your in good ...   Georgelofi

06-15-10   Proabably getting quite a bit of warmth, dimensionality, pal ...   Pubul57

06-16-10   Clio9, could you share what those atma sphere tweaks are? al ...   Tompoodie

06-16-10   Tompoodie also, is anyone aware of a mechanical switching bo ...   Georgelofi

06-16-10   George, are you, or could you, consider making a fully bala ...   Koestner

06-16-10   no. please contact ralph directly. the tweaks may not be ap ...   Clio09

06-16-10   Since the resistor changes with the amount of light, could i ...   Koestner

06-16-10   Many thanks george and clio09. i'm going to give the lights ...   Tompoodie

06-16-10   Tompoodie, music reference rm-10 + lightspeed attenutor = d ...   Clio09

06-16-10   I agree anthony, as enjoyable as several $10-$20,000 combos ...   Pubul57

06-16-10   06-16-10: koestner:george, are you, or could you, consider ...   Georgelofi

06-16-10: Tradeontheweb
"I agree Anthony, as enjoyable as several $10-$20,000 combos I had here over the past 5-7 years. With the right speakers, the LS-A/RM10 combo($2,400 list)is incredibly good and competitive with just about any pre/amp combo out there, at any price"

Just my 2 cents worth in agreement with the above. Having recently listened to the LS inserted into an expensive system with Halcro Monoblocks (approx AUD $60K)and both Wilson 7's and 8's, I can vouch for the LS's ability to play in any company and far exceed it's modest price/appearance.

Cheers

Scott

Tradeontheweb  (System | Threads | Answers | This Thread)


06-16-10   Well we may never get to the point that we can say of any pr ...   Pubul57

06-16-10   Scott, that would only be in a small room with highly effici ...   Grannyring

06-16-10   I would think a room much larger than 12x18 would be too lar ...   Pubul57

06-16-10   Also, on the rm10, i'm driving merlins with its 35 watts (ac ...   Pubul57

06-16-10   i don't see why not, but i'll let george address this. i th ...   Clio09

06-16-10   06-16-10: grannyring:i have a question for you owners of th ...   Georgelofi

06-16-10   George, do you think the quality of the power supply of the ...   Pubul57

06-16-10   I also feel the need to share this story, because it offers ...   Clio09

06-16-10   Pubul57, what is the active preamp "conditioning"? ...   Clio09

06-16-10   Pubul57 george, do you think the quality of the power supply ...   Georgelofi

06-16-10   No, thinking more in terms of power delivery and power suppl ...   Pubul57

06-16-10   06-16-10: pubul57 no, thinking more in terms of power delive ...   Georgelofi

06-16-10   what type of cabling should one use (or do you use) in term ...   Clio09

06-16-10   The cardas gr have really low capacitance, but the blue jean ...   Pubul57

06-16-10   "06-16-10: grannyring scott, that would only be in a sm ...   Tradeontheweb

06-16-10   I use express 6 mkii interconnect by eichmann but i don't wi ...   Georgelofi

06-17-10   Scott, you agreed with me actually as i was talking about ab ...   Grannyring

06-17-10   Grannyring, thanks for that - i wondered if that was what yo ...   Tradeontheweb

06-17-10   Ok, one last question. if i run my cd player right into my a ...   Grannyring

06-17-10   Bill - go to the arthur salvatore site and read the instruc ...   Clio09

06-17-10   Thanks tony, my cd player is a cary 306. it puts out 3v - h ...   Grannyring

06-17-10   Bill, while the 3v output of the cdp is quite sufficient, t ...   Clio09

06-17-10   Anthony, i'm not sure if you would know this, but if a cd pl ...   Pubul57

06-17-10   Paul, to me, if 2v plays loud enough then go with the lower ...   Clio09

06-17-10   Correct me if i am wrong. i understand that in applying atte ...   Milpai

06-17-10   Interesting point, i'd be interested in someone confirming t ...   Clio09

06-17-10   Maybe it is the input impedance of the ls that is constant? ...   Pubul57

06-17-10   Wow busy while i was asleep. pubul57 anthony, i'm not sure i ...   Georgelofi

06-17-10   Grannyring ok, one last question. if i run my cd player righ ...   Georgelofi


< Prev 1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 >> Next >

  Post your response
Subject


Your response

No html, but you may use markup tags


Username
Members only

Password