AudiogoN
Search Buy Sell Learn MyPage
 Learn > Forums > Amps Preamps > 1276356977  Start New Thread | Log In | Bookmark This
  Lightspeed Attenuator - Best Preamp Ever?
The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
Pubul57  (System | Threads | Answers | This Thread)

06-12-10
  Responses (651-700 of 1334)
Click title to read one, or click date to read all below it.

03-02-11   Kevinzoe am i missing anything by not having the volume at a ...   Georgelofi

03-02-11   Clio09 - thanks for taking the time to do your homework befo ...   Kevinzoe

03-02-11   Just looked at the specs of the sony cdp-ca7es and the 10k f ...   Georgelofi

03-02-11   Definitive answer:)   Pubul57

03-02-11   The diy diffuser write-up was helpful, but after looking at ...   Clio09

03-02-11   George - thank you for chiming in. glad to hear that no soni ...   Kevinzoe

03-03-11   Can you guys tell me how the compatibilty would be in my set ...   Jman

03-03-11   Perfect enough.   Pubul57

03-03-11   You would want to use the fixed outputs, not the variable ou ...   Clio09

03-03-11   Thank you pubul57 and clio09...i think i will give it a try.   Jman

03-03-11   Just a heads up for any looking for a very low capacitance c ...   Lstack

03-03-11   Cardas gr, 12pf/ft. lstack, sure that's not per foot?   Pubul57

03-03-11   No need to do the a typical audiophile thing here, and go ov ...   Georgelofi

03-03-11   Dnm datasheet states 13.2pf/meter: http://www.dnm.co.uk/da ...   Banquo363

03-04-11   Wow! that has to be the lowest capacitance if any cable - no ...   Pubul57

03-04-11   I was rading a review of some vh audio power cords" by ...   Pubul57

03-04-11   I was actually "reading" it:)   Pubul57

03-04-11   the extremely low capacitance results from the flat construc ...   Almarg

03-07-11   I have a wallwart i purchased from circuit-test. it is 12vdc ...   Pubul57

03-07-11   Linear and regulated - whatever that means.   Pubul57

03-07-11   Yes, you want the linear regulated ps, not a switching ps. 4 ...   Clio09

03-08-11   That's what i have:) the battery test is next!   Pubul57

03-09-11   George, this may be an odd question to ask a designer, but c ...   Pubul57

03-10-11   None really, it's maxed out because of it's simplicity, the ...   Georgelofi

03-10-11   I can think of one: if a remote were built into the product, ...   Atmasphere

03-10-11   I like it:)   Pubul57

03-10-11   Sounds good to me. seems like remote ldr options exist out t ...   Clio09

03-10-11   On the famous diy thread, it appears that have some tried th ...   Pubul57

03-10-11   No negative impact using a remote, but no improvement in sou ...   Georgelofi

03-10-11   Reliability is golden. i certainly would not be interested i ...   Pubul57

03-10-11   I have the evs attenuators and the concept is pretty sound i ...   Clio09

03-10-11   You know anthony, it just might be that the lsa is what it i ...   Pubul57

03-10-11   The only other possibility is to put it inside the actual am ...   Clio09

03-10-11   To reconfigure it and have it so it plugs directly into the ...   Georgelofi

03-11-11   George, i appreciate that you want to keep it simple but you ...   Atmasphere

03-11-11   Like i said two lager than cigarette size boxes hanging off ...   Georgelofi

03-11-11   Of course, if your amp has its inputs in front.... anybody ...   Swampwalker

03-11-11   :) ....   Pubul57

03-12-11: Clio09
There's a stereo amp with inputs in the front too;)
Clio09  (System | Reviews | Threads | Answers | This Thread)


03-13-11   Just picked up one of the preamps today on the 'gon, mkii. i ...   Gooddomino

03-13-11   You have no gain issues. you should no ic capacitance issues ...   Pubul57

03-13-11   What is the source?   Pubul57

03-13-11   Have a level one plus modded music hall 25.2. gain is 2.5v. ...   Gooddomino

03-13-11   The music hall is a dac? they use an tube output stage?   Pubul57

03-13-11   I am asking because the output impedance of the dac or cd pl ...   Pubul57

03-13-11   They are both solid state cdps, should be fine. i'd recommen ...   Clio09

03-13-11   It is a ss cdp.   Gooddomino

03-13-11   I'll check into the shielded vs. non shielded issue. i know ...   Gooddomino

03-13-11   I use mogami: http://www.audiogon.com/cgi-bin/cls.pl?cabli ...   Clio09

03-13-11   Anthony do you know if the cable in that rca is mogami 2534 ...   Pubul57


< Prev << 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 | 17 | 18 | 19 >> Next >

  Post your response
Subject


Your response

No html, but you may use markup tags


Username
Members only

Password