AudiogoN
Search Buy Sell Learn MyPage
 Learn > Forums > Amps Preamps > 1276356977  Start New Thread | Log In | Bookmark This
  Lightspeed Attenuator - Best Preamp Ever?
The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
Pubul57  (System | Threads | Answers | This Thread)

06-12-10
  Responses (551-600 of 1334)
Click title to read one, or click date to read all below it.

01-18-11   Capacitors on output stages of dacs and cdp's are evil neces ...   Georgelofi

01-19-11   Having done some audition in this regard (we 'switched', if ...   Atmasphere

01-20-11   We are on the same wave length, like i've said on the lights ...   Georgelofi

01-23-11   here's an interesting snippet from the latest stereophile r ...   Georgelofi

01-24-11   Interesting comparison between running direct to amp and the ...   Clio09

01-24-11   "i quickly put a stop to it showing proof to the patent ...   Pubul57

01-24-11   Quote from the stereophile review of the dartzeel nhb-18ns & ...   Georgelofi

01-24-11   Apparently not the first time in all audio history:)   Pubul57

01-24-11   Lol. great stuff.   Clio09

01-25-11   Lightspeeders, with george's permission i'll be starting a l ...   Clio09

01-26-11   Sign me up!   Pubul57

01-26-11   I'll email you details on how to sign up. hopefully, i've co ...   Clio09

02-03-11   Count me in too please !   Tradeontheweb

02-03-11   Sent you an email with instructions. look forward to getting ...   Clio09

02-04-11   Please count me in. thanks   Vicks7

02-04-11   Anthony, did you get my info?   Pubul57

02-06-11   Just a quick note. those of you who requested access to the ...   Clio09

02-06-11   I really like the thread interface you have on the site, ver ...   Pubul57

02-06-11   Oh, and congratulations and good luck on the electra-fidelit ...   Pubul57

02-06-11   I'm using a content management tool for the layout and publi ...   Clio09

02-10-11   I asked this elsewhere but wanted to move this discussion he ...   Jult52

02-10-11   What are you speakers?   Pubul57

02-10-11   Pubul - magnepan mmgs. why does this matter?   Jult52

02-10-11   If your speaker are 92db and you have 500 watts, loosing 75% ...   Pubul57

02-10-11   I don't think the output, input shortfall would be heard in ...   Pubul57

02-10-11   Pubul - i see. so you are saying that i would indeed lose s ...   Jult52

02-10-11   That is above my pay grade:) i think george could answer the ...   Pubul57

02-10-11   Paul, i'm not certain but i suspect that the reason for the ...   Almarg

02-10-11   Almarg, i suspect you are right, ralph's spec sheets don't s ...   Pubul57

02-10-11   my guess is that it would not be a problem, especially consi ...   Almarg

02-10-11   all this is not an issue, most amps/speakers are fine. if ...   Georgelofi

02-10-11   I think you'll be fine. your cd has a good amount of output ...   Clio09

02-10-11: Almarg
George, note that the issue is not whether or not the volume control will have to be used too close to the bottom of its range. The issue is that even with the volume control set to its maximum position, a substantial fraction of the power capability of the amp (perhaps half) will not be able to be utilized. And keep in mind that the gentleman's speakers are relatively insensitive, at 83db/1W/1m.

I doubt it will be a problem, as I indicated, but that is the issue.

Best regards,
-- Al

Almarg  (System | Threads | Answers | This Thread)


02-11-11   Jult52, you have no worries, in fact this is more of an idea ...   Atmasphere

02-11-11   Thanks ralph is a very important bit of information and affe ...   Pubul57

02-11-11   George, this may have been asked elsewhere in the thread, bu ...   Pubul57

02-11-11   I would say that with this low 83db speaker, your amps input ...   Georgelofi

02-11-11   Thank you for the responses and information, gentlemen. it' ...   Jult52

02-11-11   Pubul57, it could well be that there could be some advantage ...   Atmasphere

02-11-11   A balanced version could be built and george has a schematic ...   Clio09

02-11-11   Thank you ralph, thank you anthony.   Pubul57

02-11-11   Any suggestions for a readily available power supply?   Swampwalker

02-11-11   Circuit-test electronics rp-1240r-p   Pubul57

02-11-11   Battery or wall wart? if you want a battery ps look here: ...   Clio09

02-11-11   This is the best battery, it's lithium-ion, rechargable (no ...   Georgelofi

02-12-11   G, have you come to believe that a battery approach sounds b ...   Pubul57

02-12-11   everyone who has bought one, including sam tellig from ste ...   Georgelofi

02-12-11   Well, i'm going to have to try it, anthony has a link for th ...   Pubul57

02-12-11   The battery i use is the same one the designer of my turntab ...   Clio09

02-12-11   The one on your site is the next model up?   Pubul57


< Prev << 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 | 17 >> Next >

  Post your response
Subject


Your response

No html, but you may use markup tags


Username
Members only

Password