AudiogoN
Search Buy Sell Learn MyPage
 Learn > Forums > Amps Preamps > 1276356977  Start New Thread | Log In | Bookmark This
  Lightspeed Attenuator - Best Preamp Ever?
The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
Pubul57  (System | Threads | Answers | This Thread)

06-12-10
  Responses (1251-1300 of 1334)
Click title to read one, or click date to read all below it.

05-14-12   I was just told about paul's passing and i was deeply sadden ...   Bobbyapalkovic

05-15-12   Thank you bobby and everyone else posting on this board and ...   Audiodynamo

05-16-12   Yes, whether it was bobby, ralph karsten, or roger modjeski, ...   Clio09

05-23-12   Ah, geez. say it ain't so! paul introduced me to merlin, bob ...   Socrates7

05-26-12   I've been having issues with the sound out of my system and ...   Banquo363

05-26-12   Are you able to try another preamp in the chain to see if th ...   Clio09

05-26-12   Thanks, clio09. i think i figured it out. i was premature in ...   Banquo363

05-26-12   I can bring my soldering iron to the show if you want to hau ...   Clio09

05-27-12: Banquo363
Well, I spent the day learning how to solder and fixing the detached wire. While it was fun, it didn't help. The very first track I played after all that revealed the same problem.

So, I dragged out a beater preamp (thanks for the suggestion, clio09) I had stored in the garage and hooked it up and listened for 45 minutes: no issues. Afterwards, I immediately plugged in the LSA and replayed the same cd: problem returns.

So, it's not the amp after all. It must be the LSA. I tried a different wall wart and the problem persists. I tried a different outlet and the problem persists. As I noted above, the problem is not channel specific: imaging is centered as usual. Perhaps there's a power regulation problem in my unit?

I should note that one of the output rca jacks is loose, but that's been that way ever since I've had the unit. By loose I mean I can rotate it a quarter turn back and forth with little resistance. If I try to go past the quarter turn, there's resistance.

Anyone else experience these symptoms?

Clio09: do you or your tech know the insides?; I'm loathe to send it to Australia but it'll be easy to carry it to Newport Beach :).

Banquo363  (System | Threads | Answers | This Thread)


05-27-12   If necessary i can have my partner look at it but that would ...   Clio09

05-27-12   Hi guys, i need to get info to scot hull that he has asked f ...   Georgelofi

05-27-12   Lsa at the show newport. i forgot to mention for those tha ...   Clio09

05-28-12   George you need to go his email, parttimeaudiophile@comcast ...   Grannyring

05-29-12   Tried that one 4 times, keeps boucing back. ----- the follo ...   Georgelofi

05-29-12   He has a facebook page also if you are on facebook?   Grannyring

05-29-12   don't do face book, not into it at all. i joined it ages ag ...   Georgelofi

05-29-12   clio09, i hope to stop by :-) best regards, sam   C1ferrari

05-31-12   Look forward to meeting you sam. i will obviously be there a ...   Clio09

06-01-12   Wish i could come and hear/see, a little far though 10,000ml ...   Georgelofi

06-05-12   There are light's being turned on in all circles now even pa ...   Georgelofi

06-28-12   I recently put the lightspeed up against three active preamp ...   Augwest

06-29-12   Augwest, are you placing the merlin bbam upstream or downstr ...   Dgarretson

06-29-12   Excellent question. i've got the master bam upstream of the ...   Augwest

06-30-12   Thanks for the comparison. i have used my lsa with an atma-s ...   Clio09

07-01-12   Hi paul (augwest) i had no idea that was you that gave the g ...   Georgelofi

07-03-12   Once again a very insightful question. the hitch for me is ...   Augwest

07-03-12   Augwest, iirc the bbam is a capacitive load with 40k input i ...   Dgarretson

07-03-12   You are correct dave, from what i've been told the $23k dart ...   Georgelofi

07-05-12   Just to let you lightspeed attenuator owners know, stereophi ...   Georgelofi

07-06-12   Great news george. to celebrate the award i gave my lightspe ...   Clio09

07-06-12   Well deserved.   Banquo363

07-08-12   Hi guys, does anyone know "devilboy" "luka k ...   Georgelofi

07-09-12   I think he has a system on here, why don't you post to his s ...   Whart

07-09-12   Yes he has even posted on this thread a few times, and he is ...   Georgelofi

07-09-12   Maybe it is a different devil boy. the guy i'm thinking of d ...   Whart

07-09-12   And he does show a lightspeed attenuator in his system. here ...   Whart

07-09-12   Thanks for the help whart that could be him but still no way ...   Georgelofi

07-09-12   Hey, thanks to george, minh, and whart for helping out here! ...   Devilboy

07-09-12   Ah great it was driving me nuts, this is not the place to st ...   Georgelofi

07-09-12   I don't get why the 'new' audiogon prevents private messagin ...   Whart

07-09-12   Postscript- i hadn't realized that the original thread start ...   Whart

07-09-12   George: ok. i will contact you from a computer that does n ...   Devilboy

07-15-12   Purchased a lightspeed from george due to what i read in thi ...   Seshkir

07-15-12   Looks like paul did it again. r.i.p.   Devilboy

07-16-12   Seshkir hi, thanks you for your encouragement and for the gr ...   Georgelofi

07-20-12   Thanks george, yes my father is looking forward to receiving ...   Seshkir

07-24-12   Your lightspeed attenuator now has wings, it should get to y ...   Georgelofi

09-15-12   For all the owners of the lightspeed attenuator, you will ag ...   Georgelofi

10-02-12   Thank you george!   Devilboy

10-03-12   Congrats george, a job well done.   Clio09


< Prev << 17 | 18 | 19 | 20 | 21 | 22 | 23 | 24 | 25 | 26 | 27 Next >

  Post your response
Subject


Your response

No html, but you may use markup tags


Username
Members only

Password