AudiogoN
Search Buy Sell Learn MyPage
 Learn > Forums > Amps Preamps > 1276356977  Start New Thread | Log In | Bookmark This
  Lightspeed Attenuator - Best Preamp Ever?
The question is a bit rhetorical. No preamp is the best ever, and much depends on system context. I am starting this thread beacuase there is a lot of info on this preamp in a Music First Audio Passive...thread, an Slagle AVC Modules...thread and wanted to be sure that information on this amazing product did not get lost in those threads.

I suspect that many folks may give this preamp a try at $450, direct from Australia, so I thought it would be good for current owners and future owners to have a place to describe their experience with this preamp.

It is a passive preamp that uses light LEDs, rather than mechanical contacts, to alter resistance and thereby attenuation of the source signal. It has been extremely hot in the DIY community, since the maker of this preamp provided gernerously provided information on how to make one. The trick is that while there are few parts, getting it done right, the matching of the parts is time consuming and tricky, and to boot, most of use would solder our fingers together if we tried. At $450, don't bother. It is cased in a small chassis that is fully shielded alloy, it gets it's RF sink earth via the interconnects. Vibration doesn't come into it as there is nothing to get vibrated as it's passive, even the active led's are immune as they are gas element, no filaments. The feet I attach are soft silicon/sorbethane compound anyway just in case.

This is not audio jewelry with bling, but solidly made and there is little room (if any) for audionervosa or tweaking.

So is this the best preamp ever? It might be if you have a single source (though you could use a switch box), your source is 2v or higher, your IC from pre-amp to amp is less than 2m to keep capaitance low, your amp is 5kohm input or higher (most any tube amp), and your amp is relatively sensitive (1v input sensitivity or lower v would be just right). In other words, within a passive friendly system (you do have to give this some thought), this is the finest passive preamp I have ever heard, and I have has many ranging form resistor-based to TVCs and AVCs.

In my system, with my equipment, I think it is the best I have heard passive or active, but I lean towards prefering preamp neutrality and transparency, without loosing musicality, dynamics, or the handling of low bass and highs.

If you own one, what are your impressions versus anything you have heard?

Is it the best ever? I suspect for some it may be, and to say that for a $450 product makes it stupidgood.
Pubul57  (System | Threads | Answers | This Thread)

06-12-10
  Responses (1201-1250 of 1334)
Click title to read one, or click date to read all below it.

04-07-12   George, it is also the case that the lsa does not permit zer ...   Pubul57

04-07-12   The attenuation range does not go low enough so even at full ...   Clio09

04-11-12   I kinda think it is the best volume control ever. i've tried ...   Dhcod

04-11-12   Gooddomino, what is your system? i have the same concern.   Plinko

04-11-12   What is your concern? you have very high gain speakers and v ...   Pubul57

04-11-12   Concern is same is gooddomino's issue. highly sensitive spea ...   Plinko

04-11-12   Sorry pubul57...just went back and read your opening comment ...   Plinko

04-11-12   I sold the lsa and just got the emia a few days ago 9 can't ...   Pubul57

04-11-12   If indeed the emia uses the slagleman autoformer modules wit ...   Clio09

04-11-12   I've not looked inside the vented case (why vented?) - what ...   Pubul57

04-11-12   Plinko, please see my 3-29 post for component list. i really ...   Gooddomino

04-11-12   Can you get to 9? or is that simply too loud at that point? ...   Pubul57

04-11-12   I get to 9 easily without it being too loud. 12 gets me pret ...   Gooddomino

04-11-12   Anthony, it looks like the slagle auto former with the chapm ...   Pubul57

04-11-12   I believe to achieve mute on the lsa would require that the ...   Banquo363

04-11-12   Paul, yours will either look like this (pic at top of page): ...   Clio09

04-11-12   There is no way around the lack of muting issue at "0&q ...   Clio09

04-11-12   It looks like the one on top on the intact audio site. i w ...   Pubul57

04-12-12   Its quite possible that john chapman's modules can not be im ...   Clio09

04-12-12   I see that george recommended lowering my gain of the amp or ...   Gooddomino

04-12-12   I don't think it has much to do with impedance. it is the i ...   Pubul57

04-12-12   My krell amp has an input sensitivity of 1.34 v rms and gain ...   Gooddomino

04-12-12   sensitivity (the input voltage that will result in the amp p ...   Almarg

04-12-12   There is nothing wrong with the gain structure of your syste ...   Clio09

04-12-12   What he said:)   Pubul57

04-12-12   If i knew about the rothwells i might have kept the cat pre/ ...   Pubul57

04-12-12   i should add to this statement, though, that since on occasi ...   Almarg

04-12-12   Thanks guys,i'll check into the rothwells. i did plug my tun ...   Gooddomino

04-12-12   Yes, the transport has no relation to the issue. the proble ...   Almarg

04-12-12   So the 10db rothwelll should get you to the similar volume l ...   Pubul57

04-12-12   I don't vouch for the rothwell's but in this particular case ...   Clio09

04-13-12   I see gene reuben audio does carry the attenuators. looks li ...   Gooddomino

04-13-12   Gene is a good guy to buy from. let us know how they work fo ...   Clio09

04-16-12   Wow this threads been active since i went on an outback holi ...   Georgelofi

04-18-12   This thread truly has a life of its own! i regret to inform ...   Audiodynamo

04-19-12   That's so sad. paul was one of the great ones on audiogon. ...   Banquo363

04-19-12   I am so sad/shocked about this news, paul was a great audiop ...   Georgelofi

04-19-12   This is quite shocking and sad. my condolences go out to his ...   Clio09

04-19-12: Almarg
This is terrible, shocking, and saddening news. RIP, Paul. Our discussions have been a pleasure and a privilege.

-- Al

Almarg  (System | Threads | Answers | This Thread)


04-19-12   That's really sad and somewhat shocking. he was a true audi ...   Agear

04-19-12   My sincere sympathy to the rosenthal family. i always enjoye ...   Charles1dad

04-20-12   I would like to express my sincere thanks to paul for starti ...   Kevinzoe

04-21-12   So sad to hear of this. my deepest sympathy goes out to pau ...   Devilboy

04-22-12   Deep sympathy to the family and the community. paul has been ...   Tristone

04-24-12   I own a lightspeed and used it until i recently stumbled upo ...   Knever

05-05-12   Wow, i was just corresponding with paul on this very topic! ...   Augwest

05-06-12   I don't read this thread consistently ... strange, yesterday ...   Knghifi

05-06-12   Ditto. have not checked in here in a while. was floored by ...   Swampwalker

05-06-12   Yes, i was also floored by this news about paul. he has em ...   Grannyring

05-13-12   Paul was soul of these forums. had several offline discussio ...   Sstalwar


< Prev << 17 | 18 | 19 | 20 | 21 | 22 | 23 | 24 | 25 | 26 | 27 Next >

  Post your response
Subject


Your response

No html, but you may use markup tags


Username
Members only

Password